Before You Call For Service

If you are having an operating problem, check this chart to see what might be the cause before you caIl for assistance.

IPERATING PROBLEM					CHECK IF
Washer	will	not fill.		.	Power cord is plugged into a live circuit
					with proper voltage.
				.	Household fuse has blown or circuit
					breaker has tripped. Check if time-delay
					fuse has been used.
				. Both hot and cold water faucets are
					open.
				. Water supply hoses are kinked.
				. Cycle control knob is set and pulled out.
Washer does not spin.				.	Lid is closed.
				.	Power cord is plugged into a live circuit
					with proper voltage.
				. Household fuse has blown or circuit
					breaker has tripped. Check if time-delay
					fuse has been used.
Washer	stops		during a	.	Washer pauses briefly at different times
cycle.					in each cycle. These pauses are normal.
				.	Power cord is plugged into a live circuit
					with proper voltage.
				.	Household fuse has blown or circuit
					breaker has tripped. Check if time-delay
					fuse has been used.
Washer	fills	and drains		.	Cycle control knob is pointing to a
without	running.				number in the cycle.
Washer	drains		during	.	Drain hose is higher than the water
wash and rinse cycles or					level in the washer.
water siphons			out.

. Firmly plug power cord into electrical outlet. Check circuit voltage at your home’s fuse/circuit breaker box.

. Replace fuse with a time-delay fuse of the correct capacity. Reset circuit breaker.

nOpen both faucets.

nStraighten hoses.

I Set cycle control knob and pull out firmly.

nClose lid firmly.

nFirmly plug power cord into electrical outlet. Check circuit voltage at your home’s fuse/circuit breaker box.

IReplacefuse with a time-delay fuse of the correct capacity. Reset circuit breaker.

m Wait a minute to see if washer starts cycle again.

nFirmly plug power cord into electrical outlet. Check circuit voltage at your home’s fuse/circuit breaker box.

IReplacefuse with a time-delay fuse of the correct capacity. Reset circuit breaker.

nSet cycle control knob on correct number in the cycle.

nAdjust dram hose so that it is higher than the water level in the washer.

Page 11