To start, To change load size, Wash cycles

Set cycle, water temperature and wash time

To start

Pull cycle control knob out. The washer will fill to the selected water level and water temperature. Immediately after filling, the washer will agitate for a selected number of minutes. Agitation can occur with the washer lid up or down. The washer will pause briefly throughout each cycle. These pauses are normal for washer operation,

To change load size

The washer will automatically fill for highest water level when cycle control knob is turned to 14 or 10 minutes in the REGULARHEAVY Cycle, or to 6 minutes in the SHORTCycle.

For smaller load sizes (and a lower water fill), follow these steps:

1. Push cycle control knob in and turn

clockwise to 14 minutes (for hot

Water temperature and load size are selected through wash time.

. Hot water can be selected by turning cycle control knob to 14 minutes in the REGULARHEAVY Cycle. Rinses are cold.

. Warm water can be selected by turning cycle control knob to 10 minutes in the REGULARHEAVY Cycle, or to 6 minutes in the SHORT Cycle. Rinses are cold.

Push in cycle control knob and turn it clockwise. Stop when indicator on knob’s outer ring points to the number in the wash cycle you want. The numbers are minutes of wash time.

Wash cycles

Regular Heavy (14 min.) Wash sturdily constructed fabrics (i.e. cotton) or heavily soiled items.

Regular Heavy (10 min.) Wash moder- ately soiled fabrics.

Short (6 min.) Gently wash lightly soiled delicates and washable knits.

NOTE: Use shorter wash times for lightly soiled loads. Loads with only a few small items need less wash time for best results.

To stop at any time

Push cycle control knob in. To restart, pull cycle control knob out.

Laundry Tip

For best cleaning results, use: -Hot wash water for normally soiled, permanent press and

synthetic items; white and color- fast cottons; heavy soils and diapers.

-Warm wash water for knits; dark or non-colorfast colors; washable woolens; moderate soil.

-Cold wash water for lightly soiled fabrics; some non-colorfast colors.

Dry detergents can spot-fade wet laundry. If using cold water, dissolve recommended amount of detergent in one quart (1 L) of warm water before adding it to the washer, or use a liquid detergent,

water) or 10 minutes (for warm

water) in the REGULARHEAVY

Cycle.

2. Pull cycle control knob out. The

washer will start to fill.

3. When the washer reaches the

desired water level, push cycle

control knob in and turn clockwise

until it points to 6 minutes in the

REGULARHEAVY Cycle.

4. Pull out cycle control knob to start

the washer.

Page4