Radio Shack 49-1010 manual Campus Security Kit, Using your doorstop alarm, What’s included

49-1010

Campus Security Kit

doorstop alarm

window alarm

trigger anchor

using your doorstop alarm

The door stop alarm is for indoor use only.

1.Remove battery compartment cover, and insert one 9V battery (not supplied) as shown. Slide ON/OFF to ON.

ON/OFF

using your window alarm

Your window alarm comes with four LR44 button-cell batteries installed. Before use, test the batteries as follows:

1. Slide to Lo or Hi. 

2. Push this button. If

the red LED lights, the batteries are

good. If the LED does

UV proof window decals (2)	2.	Insert the alarm
		at the base of your
keychain alarm with light		door, making sure
		the non-skid pad
		on the bottom
		of the alarm is in
		firm contact with
double-sided		the floor. When the door is opened,
		the alarm’s metal plate is depressed,
adhesive tape (1)
		which presses down the trigger
Thank you for purchasing your Campus		anchor and sounds the alarm.
Security Kit from RadioShack.	3. To silence the doorstop alarm, turn it
what’s included		OFF.

doorstop alarm	keychain alarm	4. Press down on the metal wedge so
		that it is positioned where it will
window alarm	UV proof window decals (2)	depress the trigger anchor.
	double-sided adhesive tape (1)

Please read this user’s guide before

installing, setting up and using your new product

www.radioshack.com

not light, replace the

3.Slide off the battery cover to replace the batteries.

Mounting your Alarm

1.Mount your window alarm indoors, on a window pane.

2.Apply the supplied adhesive tape onto a window pane, with the side labeled “ACTIVE” facing outside for external visibility. Then, firmly press the window alarm onto the adhesive tape.

3.Slide to Hi or Lo to arm. Hi provides more sensitivity for a larger area; Lo is suitable for use in a smaller area.

4.Apply the UV proof window decal on the window.

5.Slide to OFF to disarm the unit.