Smeg LBS128F manual Auxiliary functions, Time display, Starting the Program, Progress of program

Auxiliary functions

Auxiliary Function Selection Buttons Select the required auxiliary functions before starting the program.

C Some combinations cannot be selected together. (Ex.: Pre-wash and Quick Wash.

Warning signal on the selected auxiliary function will light up.

Auxiliary function selection

If an auxiliary function that should not be selected together with a previously selected function is chosen, the first selected function will be cancelled and the last auxiliary function selection will remain active.

(Ex.: If you want to select pre-wash first and then quick wash, pre-wash will be cancelled and quick wash will remain active.

Auxiliary function that is not compatible with the program cannot be selected. (see, “Program Selection Table”)

C Auxiliary function buttons may differ according to the model of your machine.

• Prelavaggio (Prewash)

A pre-wash is only worthwhile for heavily soiled laundry. Without pre-wash you save energy, water, detergent and time.

C Pre-wash without detergent is recommended for lace and curtains.

• Rapido (Quick Wash)

This function can be used for “Cottons” and “Synthetics” programs. It decreases the washing times for lightly soiled laundries and also the number of rinsing steps.

• Risciacquo Aggiuntivo (Rinse Plus)

With this function, you can increase the number of current rinsing steps. Thus, sensitive skins’ risk of being affected by the remainder detergent on the clothes will be decreased.

• Anti-Creasing

With this function, drum movement will be lessened to prevent creasing and spinning speed is limited. In addition, washing is carried out at a higher water level.

C Whenever you select this auxiliary function, load your machine with half of the maximum laundry specified in the program table.

• No Heat

If you wish to wash your clothes in cold water, you can use this program.

Time display

The display shows the time remaining for the program to complete while a program is running. Program duration may differ from the values in the consumption table subject to the changes in the water pressure, water hardness and temperature,

ambient temperature, type and amount of laundry, auxiliary functions selected, and changes in the supply voltage.

Time delay

With the “Time delay” function you can delay the program start up to 24 hours. Time delay can be set with steps of one hour for the first three hours and with steps of three hours for the remainder (1, 2, 3, 6, 9, …24).

1.Pres “Time Delay” button to adjust the desired time.

2.Press “Start/Pause/Cancel” button. The time delay will start to count down.

C More laundry may be loaded during the time delay period.

Changing the delay time

If you want to change the time during the countdown:

1.Press “Start/Pause/Cancel” button.

2.Pres “Time Delay” button to adjust the desired time delay.

3.Press “Start/Pause/Cancel” button.

Canceling the time delay

If you want to cancel the time delay countdown and start the program:

1.Press “Start/Pause/Cancel” button.

2.Pres “Time Delay” button to decrease the time delay.

3.Press “Start/Pause/Cancel” button to start the program.

Starting the Program

1.Press “Start/Pause/Cancel” button to start the program.

2.Program follow-up lamp showing the startup of the program will light up.

Progress of program

Progress of a running program is shown through the program follow-up indicator. At the beginning of every program step, the relevant indicator lamp will light up and light of the completed step will turn off. The symbol that is lit up at the far right of the series of symbols indicates the step that is being carried out.

C If the machine is not spinning, the program may be in rinse hold mode or the automatic spin correction system has been activated due to an excessive unbalanced distribution of laundry in the machine.

8 - EN