This function protects the appliance from being tampered by children. In this case, all of the buttons are inactive except On/Off button; by On/Off button you can whether stop or resume (while
The machine is switched to
Ending the program through canceling
In order to cancel the selected program, press the “Start/Pause/Cancel” button for 3 seconds. The machine starts to discharge the water. “Wash” and “Program Finished” lights will light up. “Start/Pause/Cancel” and “Wash” lights will go off after discharging process is over and the “Lid” light will start flashing. “Lid” lamp will light up continuously when the door is unlocked.
If the program is cancelled in the middle of the process, “Wash” and “Program Finished” lights will light up. The machine can drain all the water or can take in water for 3 times at most to cool down the clothes and complete draining process. When the water discharging process is completed, the “Wash” light will go off, the “Program Finished” light will light up and the “Lid” light will continuously flash until the door is unlocked.
End of program
The “Program Finished” lamp on the program
If any key is pressed when the machine is at the end of the program or if the position of the selection knob is changed, the “Program Finished” light will go off and only the “Lid” lamp will remain as lit. If the door is still locked, the “Lid” light will continue flashing until the door is unlocked.
Press the “On/Off” button to shut down the machine.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the drawer. To do this;
1.Press the dotted point on the siphon in the softener compartment and pull towards you until the compartment is removed from the machine.
CIf more than a normal amount of water and softener mixture starts to gather in the softener compartment, the siphon must be cleaned.
2.Wash the dispenser drawer and the siphon with plenty of lukewarm water in a washbasin.
3.Replace the drawer into its housing after cleaning. Check if the siphon is in its original location.
Inlet water filters
There is a filter at the end of each water intake valve at the back side of the machine and also at the end of each water intake hose where they are connected to the tap. These filters prevent the foreign substances and dirt in the water to enter into the machine. Filters should be cleaned as they get dirty.
•Close the taps.
•Remove the nuts of the water intake hoses to clean the surfaces of the filters on the water intake valves with an appropriate brush.
•If the filters are very dirty, you can pull them out by means of pliers and clean them.
•Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under streaming water.
•Replace the gaskets and filters carefully to their places and tighten the hose nuts by hand.
9- EN