Smeg SLB600 manual Loading the Washing, Adding Detergent and Additives

Page 14

GB

5.3 PREPARING THE WASHING

Where possible, save electricity by washing full loads divided by type of fabric. Introduce loose washing and alternate large items with small ones. For the first few times, weigh the loads of washing and then rely on your judgement.

5.4LOADING THE WASHING

1.Open the door and load the washing taking care to distribute it uniformly, loosely and not packed into the drum; alternate large items with small ones if possible.

2.The washing machine described in this manual can be loaded with up to 5kg of washing. Heavier loads will lead to unsatisfactory washing results and may cause the machine to work incorrectly.

3.To save energy, wash full loads divided by type of fabric, according to the quantities indicated in the “Programmes chart” supplied with this manual.

4.Close the door by pressing it against the body of the appliance until you hear a click. Make sure no garments have got caught between the door and the rubber gasket.

Attention!

If the door is not closed properly, a safety device prevents the washing machine from working.

Do not use more than the recommended amount of detergent: too much may deteriorate washing results.

5.5 ADDING DETERGENT AND ADDITIVES

Follow the instructions shown in the “Programme Chart” provided together with the manual and add detergent and any additives to the relative compartment before starting the programme.

Pour the pre-wash powder detergent into the compartment marked “1”.

Pour main wash detergent into compartment “2”. Machine accessories include a red insert “A” that can be placed inside compartment “2” to allow liquid detergent to be used. The additives are automatically introduced into the tub during final rinsing.

Pour liquid additives such as starch and fabric softener into “3”, marked with .

If bleach can be used with the machine (no cover marked with ) add bleach to compartment “4” if you wish. The level of the liquids must not exceed the maximum limit, otherwise the trays will be emptied too soon.

Before pouring thick additives into the tray, dilute them with a little water to prevent them from obstructing the trap. Only use foam-controlled detergent suitable for use in washing machines.

Determine the quantity of detergent according to the hardness of the water, and the type, quantity and dirtiness of the washing.

This will allow you to obtain the required effect using as little detergent as possible.

Detergent packs indicate the quantities to use according to 4 levels of hardness and for normally dirty loads of 4-5 kg.

Ask your local water board to tell you how hard your water is.

Water hardness

 

 

 

Hardness level

French degree fH

German degree dH

 

Soft

Up to 15°

Up to 8°

 

Moderately hard

15° - 25°

8° - 14°

 

Hard

25° - 40°

14° - 22°

 

Very hard

Over 40°

Over 22°

14

Image 14
Contents Washing Machine Contents NEW Washing System Safety Warnings Only be performed by qualified technicians Removing the Wooden Base Installation InstructionsUnpacking Drain Connection Positioning and LevellingWater Supply Connection Electrical Connection Description of Controls Control PanelStart Wash End Quick wash Button Options enabled LEDs Detergent TrayOpening the Door Using the MachinePreparing the Washing Loading the Washing Adding Detergent and AdditivesDosing Liquid Detergents Switching on the Machine and Selecting ProgrammesDosing Powder Detergents SCALE-REMOVERSSpeed Selection Cottons, coloureds Woollens Synthetics, delicatesInterrupting or Changing the Washing Programme Selection of OptionsStarting the Washing Programme END of ProgrammeCleaning the Drum Cleaning and MaintenanceExternal Cleaning Cleaning the Drain PumpCleaning the Detergent Tray Cleaning the Water Inlet FilterTroubleshooting Error Signals Control Panel Symbols Section