GB
4.Unscrew the cover of the pump “D” by turning it
Check the inside “E” and make sure the impeller turns freely. If there are any foreign bodies, remove them.
5.Screw the pump cover back on.
Fix the drain hose by snapping the plug into place «C». Depending on the model, put back the cover as follows:
MODEL A – Insert the lower part of the cover first. Then secure it by turning the plastic buttons a quarter turn clockwise.
The slots in the buttons must be horizontal.
MODEL B – Insert the lower part of the cover first and then push it towards the base plate until it clicks into place.
6.4CLEANING THE DETERGENT TRAY
Keep the detergent tray free from scale.
To simplify this operation, completely remove the detergent tray (pull it out as far as it will go, lift it slightly and then pull fairly vigorously).
Remove the traps «B» and clean with hot water.
Put back the traps and remove any residues of detergent before putting the tray back.
6.5 CLEANING THE WATER INLET FILTER
The machine is fitted with a filter for protecting the water inlet valves.
The filter is fitted the gas thread of the inlet hose connected to the tap
Clean the filter if no water or insufficient quantities of water enter the washing machine. To do this, proceed as follows:
•Remove the plug from the socket to disconnect the machine from the electrical power supply.
•Turn off the water tap.
•Unscrew the inlet hose from the tap.
•Remove the filter from the inlet hose gas thread.
•Clean the filter with water and a brush.
•When screwing the inlet hose back on to the tap, make sure the filter is correctly positioned.
19