Failures
The washing machine automatically monitors the execution of particular functions during the operation, and reports any detected failures. In such cases both signal LED’s start flashing in certain sequence. Flashing sequence changes in accordance with the nature of the detected failure.
In some cases you may attempt removing certain failures yourself, so count the number of flashes, repeating after certain pauses.
The machine signals failures immediately after detecting them and stops the program, except for heater failure, where the machine completes the washing program without heating water.
Failures:
In certain cases you may remove the failure yourself: 2 - two flashes: door is not correctly closed;
3 - three flashes: inappropriate water intake;
7 - seven flashes: inappropriate water outlet.
In all other instances mark the number of flashes indicating the failure, switch off the machine and call nearest authorized service center (LED’s continue flashing until you switch the machine off).
Interferences from the ambient (for example electrical wiring) could induce signalization of different faults. In such cases:
-switch the appliance off, and wait for a few seconds;
-switch the appliance back on and repeat the washing program. If the fault repeats, call authorized service shop.
Warranty shall not apply in case of failures due to interferences from the environment (lightning stroke, power supply circuit faults, natural disasters).
187352
21