Smeg K600TL manual Water stop fault depending on model, Pump operates

Page 13

6GB10055.fm Page 13 Monday, August 2, 2004 12:33 PM

*Final spin results are poor.

Note: the washing machine has an unbalance detection and correction system. If individual heavy items are loaded (a bathrobe, for example), this system may reduce the spin speed automatically or interrupt the spin if it detects too great unbalance at the start of the spin, in order to protect the washing machine.

Excessive foam formation may also prevent spinning.

Check whether:

•the pump impeller is obstructed (see “Cleaning the foreign body trap”).

•if the laundry is still too wet at the end of the programme: possibly add other items of clothing and repeat the spin cycle.

•there is foam on the wash: repeat a rinse-spin cycle to eliminate excess of detergent.

Water stop fault (depending on model).

(The pump operates).

The “Water Stop” fault may have been triggered by:

•Too much foam.

•A leak in the inlet hose or in the washing machine. Switch off the washing machine, unplug it and turn off the water tap.

Tilt the washing machine forwards carefully to allow the water to evacuate from the bottom tray. Reconnect the washing machine.

Turn on water supply (if the machine is switched off, but begins to fill, turn off the water supply and contact After Sales Service).

Reselect the desired programme, add the detergent, if necessary and switch on the machine to restart the programme.

If the fault occurs again, contact After-Sales Service (see “After-Sales Service”).

GB 13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Contents Install the washing machine Before Using the Washing MachineRemove the packaging and check Electrical connection Remove the transport bracketFirst Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineSort the laundry Dyeing and bleaching Stain removalStarching Open the machine lid Loading the laundryDosage Detergents and AdditivesFilling up with detergents and additives Choice of the right detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine does not start, no lamp lights up Water inlet hosesWashing machine does not start, but the pilot lamp is on Washing machine stops during the programmeWater Stop fault may have been triggered by Water stop fault depending on modelPump operates Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemValid Only For Great Britain And Ireland Fuse replacementTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363AMax GB K 600 TLAppliance in Rinse Hold Rinse Hold buttonNo Spin button Half Load button
Top Page Image Contents