Smeg K600TL Detergents and Additives, Dosage, Filling up with detergents and additives, Medium

Page 7

6GB10055.fm Page 7 Monday, August 2, 2004 12:33 PM

DETERGENTS AND ADDITIVES

Choice of the right detergents and additives

The type of detergent depends on:

type of fabric (cottons, easy care/synthetics, delicate items, wool).

Note: use only specific detergents for wool.

colour;

washing temperature;

degree and type of soiling.

Notes:

Whitish residues on dark fabrics are caused by insoluble detergents components used in modern phosphate-free powder detergents. If you notice this problem, shake or brush the affected items or use a liquid detergents.

Keep detergents and additives in a dry place and out of reach of children.

Use only detergents and additives specifically produced for domestic washing machines.

If you use descaling agents, dyes or bleaches, make sure they are suitable for washing machine use. Descaler could contain components that can attack parts of your washing machine.

Do not use solvents (turpentine, benzine, etc.). Do not machine wash fabrics that have been treated with solvents or flammable liquids.

Dosage

Follow the instructions on the detergent pack in relation to:

the degree and type of soiling;

the size of the load;

-full load: follow the detergent manufacturer’s instructions;

-half load: 3/4 the amount used for a full load;

-minimum load (about 1 kg): half the amount used for a full load;

water hardness in your area (ask for information from your water company): soft water requires less detergent than hard water.

Notes:

Too much detergent can result in excess foam formation, and the reduction of washing efficiency. If the washing machine detects excessive foam it may prevent spinning.

Insufficient detergent may result in:

grey laundry, deposits on the drum, tub and heater. When using concentrated fabric softeners, add water in the detergents dispenser up to “MAX” level mark. To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball or bag supplied with the detergent and place it inside the drum.

WATER HARDNESS CHART

WATER

CHARACTE-

GERMAN

FRENCH

ENGLISH

HARDNESS

RISTICS

°dH

°fH

°eH

CATEGORY

 

 

 

 

1

soft

0-7

0-12

0-9

2

medium

7-14

12-25

9-17

3

hard

14-21

25-37

17-26

4

very hard

over 21

over 37

over 26

Filling up with detergents and additives

The dispenser will have three or four compartments depending on model.

Pour in the detergent:

Washing powder for prewash and main wash

Washing powder for main wash without prewash

Fabric softeners and starch products,

no more than to “MAX” mark.

Chlorine bleach, no more than to “MAX” mark.

(only four compartments model)

Stain removers

Water softeners (water hardness class 4)

Starch (dissolved in water)

Be careful not to fill more than the “MAX” level mark.

Do not use liquid detergents for programmes with prewash.

For programmes without prewash and temperatures from cold to 40° C, it is recommended to use liquid detergents to avoid whitish residues on the laundry.

GB 7

Image 7 Contents
Contents Remove the transport bracket Before Using the Washing MachineInstall the washing machine Remove the packaging and check Electrical connectionFirst Wash Cycle Precautions and General RecommendationsPreparation of the Washing Description of the Washing MachineSort the laundry Dyeing and bleaching Stain removalStarching Open the machine lid Loading the laundryChoice of the right detergents and additives Detergents and AdditivesDosage Filling up with detergents and additivesProgramme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual WaterPlug the washing machine back Water inlet hose filterWashing machine stops during the programme Water inlet hosesWashing machine does not start, no lamp lights up Washing machine does not start, but the pilot lamp is onWater Stop fault may have been triggered by Water stop fault depending on modelPump operates Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Connect the water inlet hose Adjust the feetConnect the water drain hose Water stop anti-flooding systemPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A Fuse replacementValid Only For Great Britain And Ireland To fit a new plug, proceed as followsMax GB K 600 TLHalf Load button Rinse Hold buttonAppliance in Rinse Hold No Spin button
Related manuals
Manual 20 pages 13.03 Kb