Beko WM 5140 W, WM 5140 S manual Draining any remaining water and cleaning the pump filter

Page 24

dirty.

Close the taps.

Remove the nuts of the water intake hoses to clean the surfaces of the filters on the water intake valves with an appropriate brush.

If the filters are very dirty, you can pull them out by means of pliers and clean them.

Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under streaming water.

Replace the gaskets and filters carefully and tighten the hose nuts by hand.

Draining any remaining water and cleaning the pump filter

Filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging the pump propeller during discharging of the washing water.

If your machine fails to drain the water, the pump filter may be clogged. You may have to clean it every 2 years or whenever it is blocked plugged. Water must be

drained off to clean the pump filter. In addition, water may have to be drained off completely in the following cases:

before transporting the machine (e.g. when moving house)

when there is the danger of frost

In order to clean the dirty filter and discharge the water;

1- Disconnect or unplug the machine

from the power supply.

AThere may be water at 90°C in the machine. Therefore, the filter must be cleaned only after the inside water is cooled down to avoid hazard of scalding.

2- Open the filter cap. The filter cap may be composed of one or two pieces according to the model of your machine. If it is composed of two pieces, press the tab on the filter cap downwards and pull the piece out towards yourself.

If it is composed of one piece, hold it from both sides and open it by pulling out.

3- An emergency drain hose is supplied with some of our models. Others are not supplied with this item.

If your product is supplied with an emergency drain hose, do the following as shown in the figure below:

24

EN

Image 24
Contents WM 5140 W WM 5140 S Explanation of symbols Please read this manual firstTable of Contents Your Washing Machine OverviewSpecifications General Safety Safety instructionsFirst Use Intended useIf there are children in your House Electrical connectionElectrical requirements Fitting a different plug Installation Appropriate installation locationAdjusting the feet Removing packaging reinforcementConnecting to the water supply Connecting to the drainDestroying the packaging material Disposing of the old machineInitial preparations for washing Sorting the laundryCorrect load capacity Detergent, softener and other cleaning agents Loading doorDetergents and softeners Detergent drawerSoftener Liquid detergentStarch Eliminating lime formationSelecting a Program and Operating Your Machine Control panelTurning the machine on Program selectionSpin Speed selection Program selection and consumption table Time delay Auxiliary functionsChanging and canceling the time delay Starting the ProgramProgressing a program Changing the program after the program has startedEnding the program through canceling Adding/removing laundry in standby modeChild-proof lock End of programQuick instructions for daily use Cleaning and care Detergent drawerDoor and the drum Outer cabinet and control panelDraining any remaining water and cleaning the pump filter Page Troubleshooting Problem Cause Explanation / SuggestionWater Being taken Improper position Case of a paused Washing Temperatures for a long Although prewash cycle is not selected, Items Button was Pressed Washing Start Page Guarantee Service Service once the manufacturers guarantee has expiredUK Mainland & Northern Ireland Republic of Ireland