Beko D 6082 B, D 6101 B, D 6081 B user manual

Page 7

2

Warning

• This product is designed for home use.

• Your washing machine is adjusted to 220V.

• If the fuse in your house is less than 16A than have a certified electrician deploy an 16A fuse.

• In case of transformer or non-transformer use, grounding installation must be performed with a licensed electrician. Any use before grounding is not our responsibility.

• Never place your machine over a carpet covered floor. Otherwise electrical parts of your machine may overheat. This may cause malfunction of your machine.

• Make sure hot and cold taps are connected correctly. Otherwise your laundry may come out hot and torn .

• Please call certified service for a failure of electric plug/ cable.

• Be careful about your water hoses are not old. Do not use old/torn water hoses. This may cause stain in your laundry .

• At first use, washing must be performed at Cotton 90°C program without loading with laundry for getting your machine ready for washing.

• Performance of your washing machine depends on the quality of water and hygiene compound used. If low quality and unfitting cleaning material is used the

stains will be fixed. Before washing your laundry with stain keep your attention on cleaning the laundry as explained in following pages.

Lifetime of your product is 10 years.

This is period of keeping spare parts for your machine to operate.

Because of quality control procedures there might be little amount of water in your machine.

This does not have any damage to your machine.

Your machine is programmed for starting operation again when electricity is off and on afterwards. You can not press On/Off button to cancel program. Machine will go on program when electricity is on. To CANCEL the program press >Start/Pause/Cancel< button for three seconds. (See. Canceling a program)

If pre-wash additional function led is blinking than your machine is in child-proof-lock position. (See. child- proof-lock)

If “Ready” led on program progress display is blinking program selection knob is middle position. In this case turn the knob and adjust it again. If the warning continues call authorized service.

After your machine starts operation if Start/Pause/ Cancel key starts blinking than door is not locked. Open and close the door again begin washing program

7

Image 7
Contents Washing Machine U s e r ’ s M a n u a l Page Dear Customer Contents Technical Features of Your Washing Machine Your Washing Machine Page Page Loading machine with laundry PreparationPage Control Panel Additional Functions Program Selection and Starting Machine Program selection table Program Progress Pressing On/OffChild-proof lock Function SelectionAdding laundry Time delay for program startCanceling a Program Changing ProgramEmptying Laundry End of ProgramHose Care and maintanenceDetergent Drawer SiphonCleaning Pump Filter Leveling the feet InstallationWater Connections a Water Inlet Hose Water drain hose Electrical connection Following fabric manufacturer Helpful tips on stain removalMachine does not take water Before calling service