Care and maintanence, Detergent dispensing drawer

5 Care and maintanence

Detergent dispensing drawer

Clean when necessary:

1.Open the drawer as far as possible.

2.Push down the depression on the suction cup and pull the drawer out completely.

3.Clean the drawer under warm running water. Pull off the suction cup; Clean

suction cup and opening in the drawer with warm running water, pierce the opening with a needle if necessary. Replace the suction cap.

4.Wipe off detergent residue from the drawer guides. If present,

remove calc deposits from the water-jet nozzles (inside the drawer).

Foreign matter trap

•Clean the foreign matter trap at least once after every 30 wash cycles!

•Clean foreign object trap, if foreign objects (coins, buttons, baby socks,

etc.) are blocking the suds pump.

•Drain left-over water before cleaning (see below).

Water intake filter

At the end of the water intake connection module and water inlet hose-tap side, there exists filters. These filters prevent any dirt and objects passing into the machine. It is advisable that these filters should be cleaned every 30-40 washes. To clean the filter, first turn the tap off. Then, disconnect the hose and clean the filter with a thin brush. If the filter is very dirty, you may clean it by pulling out with pliers. To clean the filter at the tap side of the hose, pull it out by hand and clean the filter under the tap water.

Hose

To prevent any leakage, have a technician to control the hoses every two years. If the machine is placed at cold ambient temperatures, the water remining inside the pump and hoses should be removed from the filters. Also to prevent freezing, empty the water intake hoses by disconnecting from taps.

Drum

Do not leave any metal objects (pins, needles, etc.) inside the drum. These objects may cause rust on the drum surface. Do not clean the drum with scratching elements.