Connection points are below water pressure there turn on tap water after connection. Check all connections for leaks In order to eliminate any risk due to water leakage keep the taps off when machine is not used.
Your machine will operate efficiently if the water from tap is minimum 1 and maximum 10 bars. Practically 1 bar means 8 liters of water in one minute when tap is fully on.
Connect dirsekli end to the machine. Tighten bolts with hand power, do not use spanner.
Double inlet models can be used with blind cap as a single inlet machine. Connect blind cap to hot water inlet. Seal must be for stopping water leakage.
Do not connect single inlet machine to hot water. If ma- chine is connected with Y part to a double inlet and over 40˚C for single inlet machines, machine may switch to protection mode.
b) Water drain hose
Water drain hose could be placed either at the side of the bath tub, or directly to the drain. The hose should not be bent. Water drain hose should be secured with the elbow so that it would not fall down on the ground.
The hose should be placed between 40 and 100 cm. from the ground.
Water drain hose could be placed directly to the drain water inlet.
21