Beko WM 6111 W Installation, Appropriate installation location, Removing packaging reinforcement

Page 8

3Installation

Refer to the nearest Authorised Service Agent for installation of the product. To make the product ready for use, review the information in the user manual and make sure that the electricity, tap water supply and water drainage systems are appropriate before calling the Authorized Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out. C Preparation of the location and

electrical, tap water and waste water installations at the place of installation is under customer's responsibility.

BInstallation and electrical connections of the product must be carried out by the Authorized Service Agent. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorized persons.

APrior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety.

C Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures.

Appropriate installation location

Place the machine on a rigid floor. Do not place it on a long pile rug or similar surfaces.

Total weight of the washing machine and the dryer -with full load- when they are placed on top of each other reaches to approx. 180 kilograms. Place the product on a solid and flat floor that has sufficient load carrying capacity!

Do not place the product on the power cable.

Do not install the product at places where temperature may fall below 0ºC.

Place the product at least 1 cm away from the edges of other furniture.

Removing packaging reinforcement

Tilt the machine backwards to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.

Removing the transportation locks

ADo not remove the transportation locks before taking out the packaging reinforcement.

ARemove the transportation safety bolts before operating the washing machine, otherwise, the product will be damaged.

1.Loosen all the bolts with a spanner until they rotate freely (C).

2.Remove transportation safety bolts by turning them gently.

8

EN

Image 8
Contents Automatic washing machine Explanation of symbols Table of Contents Your washing machine OverviewTechnical specifications Important safety instructions General safetyChildrens safety Intended usePage Installation Appropriate installation locationRemoving packaging reinforcement Removing the transportation locksConnecting water supply Connecting to the drainAdjusting the feet Electrical connectionFitting a different plug First useElectrical requirements Disposing of the old product Disposing of packaging materialTransportation of the product Preparation Things to be done for energy savingSorting the laundry Preparing laundry for washingCorrect load capacity Loading the laundryUsing detergent and softener Using gel and tablet detergent Using starchUsing bleaches Using limescale removerTips for efficient washing Soiling Level ClothesOperating the product Control panelMain programmes Preparing the machineProgramme selection Temperature selection Spin speed selectionSpecial programmes RinseProgramme selection and consumption table Child Lock Auxiliary function selectionStarting the programme Changing the auxiliary function, speed and temperature Progress of programmeLoading door lock Changing the selections after programme has startedCanceling the programme End of programmeMaintenance and cleaning Cleaning the detergent drawerCleaning the loading door and the drum Cleaning the body and control panelDraining remaining water and cleaning the pump filter Page Troubleshooting Tap is turned off. Open the inlet water taps fullyPage Select the proper temperature for the laundry to be washed Page Use smaller amounts of detergent for this type of item Foam is overflowing from the detergent drawer Guarantee Service Service once the manufacturers guarantee has expiredUK Mainland & Northern Ireland Republic of Ireland