Beko ECO WMB 81445 LW Installation Electrical connection, Electrical requirements, 12 / 44 EN

Page 12

Installation

A WARNING: Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged.

3.7 Electrical connection

Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not be liable for any damages that will arise when the product is used without grounding in accordance with the local regulations.

Connection must comply with national regulations.

Power cable plug must be within easy reach after installation.

If the current value of the fuse or breaker in the house is less than 13 Amps, have a qualified electrician install a 13 Amp fuse.

The voltage specified in the "Technical specifications" section must be equal to your mains voltage.

Do not make connections via extension cables or multi-plugs.

B Damaged power cables must be replaced by the Authorized Service Agents.

Electrical requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating label corresponds to your electricity supply.

We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket in a readily accessible position. Should the mains lead of the appliance become damaged or need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a Authorised Service Agent.

B This appliance must be earthed

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted.

Destroy the old plug, which is cut off as a plug with a bared cord could cause a shock hazard if inserted into a socket elsewhere in the house. The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be replaced an ASTA approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

Important

Fitting a different plug

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals on your plug, proceed as follows:

1Connect the green - yellow or green (earth) wire to the terminal in the plug marked ‘E’ or with the symbol f or coloured green and yellow or green.

2Connect the blue (neutral) wire to the terminal in the plug marked ‘N’ or coloured black.

3Connect the brown (live) wire to the terminal in the plug marked ‘L’ or coloured red.

With the alternative plugs a 13A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.

12 / 44 EN

Image 12
Contents Automatic washing machine ECO WMB 81445 LWDear Customer Explanation of symbols 44 ENImportant information or useful hints about usage Important instructions for safety Environment4 InstallationMaintenance and cleaning Troubleshooting Guarantee ServiceImportant instructions for safety and environment General safetyUnplug the product when not in use Service life of your product is 10 yearsPackage information Compliance with WEE DirectiveDisposing of the waste product This appliance’s packaging material isPower cable Your washing machineOverview Top panel Loading door Control panelYour washing machine Package Contents Your washing machine Technical specifications Installation Appropriate installation locationRemoving packaging reinforcement Removing the transportation locksInstallation Connecting water supply10 / 44 EN Installation Connecting to the drain Adjusting the feetInstallation Electrical connection Electrical requirementsFitting a different plug 12 / 44 EN13 / 44 EN Preparation Sorting the laundry14 / 44 EN Preparation Preparing laundry for washing Correct load capacityThings to be done for energy saving Preparation Loading the laundry Preparation Initial use 18 / 44 ENPreparation Tips for efficient washing 19 / 44 ENDisplay symbols Operating the productControl panel On / Off buttonOperating the product Preparing the machine Programme selectionMain programmes Additional programmesOperating the product Special programmesTemperature selection Spin speed selection23 / 44 EN Use a lower spin speed for delicate laundriesOperating the product Programme and consumption table 24 / 44 ENOperating the product Auxiliary function selection PrewashExtra Rinse 25 / 44 ENDelayed start Changing the delayed start periodCancelling the Delayed Start function Time displayOperating the product Starting the programme Progress of programmeLoading door lock Changing the selections after programme has startedCancelling the programme Machine is in Rinse Hold modeChild Lock End of programmeQuick User Guide 29 / 44 ENCleaning the detergent drawer Cleaning the loading door and the drum30 / 44 EN MonthsMaintenance and cleaning Cleaning the water intake filtersCleaning the body and control panel Draining remaining water and cleaning the pump filterInstall the filter Pull the emergency draining hose out from its seat32 / 44 EN Troubleshooting 33 / 44 ENProgramme cannot be started or selected Machine does not fill with waterTroubleshooting 34 / 44 EN35 / 44 EN It does not rinse well36 / 44 EN Laundry does not smell like the softenerDetergent residue in the detergent drawer Water pressure is low. Check the water pressureOn / Off button might not be pressed. Press On / Off button Loading door may be open. Close the loading door37 / 44 EN Foam is overflowing from the detergent drawerGuarantee What is covered?Or Bord Gais registered Gas Installer 38 / 44 ENService Service once the manufacturers guarantee has expired0845 600 GasComplying Commission Delegated Regulation EU No 1061/201 40 / 44 EN41 / 44 EN 42 / 44 EN 43 / 44 EN

ECO WMB 81445 LW specifications

The Beko ECO WMB 81445 LW is a front-loading washing machine that combines efficiency, functionality, and modern technology to cater to various laundry needs. With a capacity of 8 kg, this model is ideal for medium to large families, accommodating a significant amount of laundry in a single cycle.

One of the standout features of the Beko ECO WMB 81445 LW is its A+++ energy rating, which signifies its high energy efficiency. This machine is designed to reduce power consumption, making it an environmentally-friendly option for those looking to lower their carbon footprint. The inverter motor technology utilized in this model ensures a quieter washing experience while providing a longer lifespan and enhanced performance.

The large LCD display offers easy access and navigation through the different wash programs available. With 15 wash programs, including options for cotton, synthetic, and delicate fabrics, users can easily select the best setting for their laundry. The quick wash program is particularly useful for those in a hurry, efficiently cleaning lightly soiled garments in just 28 minutes.

Another notable technology is the Aqua Fusion system, which optimizes water and detergent use to prevent wastage. By ensuring that detergent is not diluted unnecessarily, it maximizes cleaning efficiency while saving resources. Additionally, the ProSmart Inverter motor is designed to reduce vibrations and noise, creating a more serene washing environment.

The Beko ECO WMB 81445 LW also features various practical options, such as the delay timer, which allows users to schedule their washes according to convenience. The child lock feature adds an extra layer of safety, preventing accidental adjustments by little hands. To top it all off, this washing machine is equipped with a self-cleaning detergent drawer, which maintains hygiene and cleanliness without extra effort.

In summary, the Beko ECO WMB 81445 LW washing machine combines user-friendly features, advanced technology, and energy-efficient performance, making it an excellent choice for families seeking reliability and convenience in their laundry routine.