Blomberg WNF 7341 A user manual Adjusting the feet, Electrical connection

Page 10

at most.

•In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out excessively wet. Therefore, follow the heights described in the figure.

•To prevent flowing of dirty water back into the machine and to allow for easy discharge, do not immerse the hose end into the dirty water or drive it in the drain more than 15 cm. If it is too long, cut it short.

•The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched between the drain and the machine.

•If the length of the hose is too short, use it by adding an original extension hose. Length of the hose may not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose and the drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak.

Adjusting the feet

AIn order to ensure that the product operates more silent and vibration- free, it must stand level and balanced on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its place and cause crushing and vibration problems.

1.Loosen the lock nuts on the feet by hand.

2.Adjust the feet until the product stands level and balanced.

3.Tighten all lock nuts again by hand.

ADo not use any tools to loosen the lock nuts. Otherwise, they will get damaged.

Electrical connection

Connect the product to a grounded outlet protected by a fuse complying with the values in the "Technical specifications" table. Our company shall not be liable for any damages that will arise when the product is used without grounding in accordance with the local regulations.

•Connection must comply with national regulations.

•Power cable plug must be within easy reach after installation.

•The voltage and allowed fuse or breaker protection are specified in the “Technical specifications” section. If the current value of the fuse or breaker in the house is less than 13

Amps, have a qualified electrician

10

EN

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Washing Machine Explanation of symbols Table of Contents Your washing machine OverviewTechnical specifications Childrens safety Important safety instructionsGeneral safety Intended usePage Removing packaging reinforcement InstallationAppropriate installation location Removing the transportation locksConnecting water supply Connecting to the drainAdjusting the feet Electrical connectionElectrical requirements First useFitting a different plug Transportation of the product Disposing of packaging materialDisposing of the old product Sorting the laundry PreparationThings to be done for energy saving Preparing laundry for washingCorrect load capacity Loading the laundryUsing detergent and softener Using bleaches Using gel and tablet detergentUsing starch Using limescale removerTips for efficient washing Soiling Level ClothesPreparing the machine Operating the productControl panel Programme selectionAdditional programmes Main programmesSpecial programmes Temperature selection Spin speed selectionProgramme and consumption table Auxiliary function selection Starting the programme Changing the Delayed Start periodCanceling the Delayed Start function Child LockChanging the selections after programme has started Canceling the programmeLoading door lock End of programmeCleaning the loading door and the drum Maintenance and cleaningCleaning the detergent drawer Cleaning the body and control panelDraining remaining water and cleaning the pump filter Page Troubleshooting Tap is turned off. Open the inlet water taps fullyPage Select the proper temperature for the laundry to be washed Page Use smaller amounts of detergent for this type of item Page Guarantee Service Service once the manufacturers guarantee has expiredBlomberg, 36-38 Caxton Way, Watford Hertfordshire, WD18 8UF
Top Page Image Contents