John Lewis 1609 Select the desired options, Select the Delay start, Start the programme

Page 18

The relevant light will light up.

1600

1200

800

500 Rinse hold

Spin

7. Select the desired options

If your laundry is very dirty, it may be advisable to select the “Prewash” option.

If you wish the laundry to undergo an extra rinse, select the “Extra Rinse” option.

The relevant light illuminates.

 

Extra

Prewash

rinse

8. Select the “Delay start”

Before you start the programme, if you wish to delay the start, press the Delay start button repeatedly, or keep it pressed, to select the desired delay. The selected delay time value (up to 20 hours) will appear on the display for a few seconds, then the duration of the programme will appear again.

Delay start

During this period it is possible to load other laundry: press the “Start/Pause” button. Open the door. Load the laundry. Close the door and press the “Start/Pause” button again.

9. Start the programme

Press the “Start/Pause” button. The relevant light will stop flashing, and only the light relevant to the phase that is in progress will remain lit. The machine starts operating.

If you have chosen a delayed start, the washer dryer will begin the countdown.

The display will show the duration of the programme or the selected delay.

10.How to change an option or a programme during its cycle

It is possible to change some options before the programme carries them out.

Before you make any change, you must pause the machine by pressing the Start/Pause button.

Changing a running programme is possible only by

resetting it.

Turn the programme selector dial to Off and then to the new programme position.

Start the new programme by pressing the Start/Pause button. The washing water in the tub will not be emptied out.

11.How to interrupt a programme

Press the Start/Pause button to interrupt a programme which is running, the corresponding light starts to flash. Press the button again to restart the programme.

12.How to open the door during the cycle of a programme

You can open the door, after having set the washing machine to Pause, provided the following conditions exist:

The machine is not in the heating phase beyond 55°C;

The level of the water is not high;

If these requirements are met, when you pause the washer dryer, the Door lock light goes off and the door can be opened.

18

Image 18
Contents Jlwd Spin washer-dryer Installation Child SafetyUse Ecological hints Maintenance and cleaningService Environmental informationContents Detergent dispenser drawer Child safety featureDescription of the appliance Prewash Main wash Fabric softenerWashing InstallationTechnical specifications DryingUnpacking Installation on a suspended floorInstall the machine on a flat hard floor PositioningWater drainage PlumbingWater inlet Appliance must be connected to a cold water supplyIf necessary, check the setting with a spirit level LevellingOnto a sink outlet spigot Interest of the environment Electrical connection Permanent connectionBlue- Neutral Brown- Live Spin button Control panelDetergent dispenser drawer Programme selector dial Position Rinse holdTime dry button Delay start buttonAutomatic Dry button OptionsDisplay Programme time Stand-by105 Selection of drying time in minutesProgramme information Child lockBuzzer Measure out the detergent Switch the machine onLoad the laundry Select the spin speed or the Rinse hold optionHow to interrupt a programme Select the Delay startHow to change an option or a programme during its cycle Select the desired optionsEnd of programme After some minutes, you can open the doorBe immediately opened DryingPress the Start/Pause button to start the programme Select the drying time or dryness degree1000g = 1 kg SheetBath robe Wash care symbols Important notesWashing programmes Energy Water Description KWh Off ResetProgramme Consumptions RinsesDrying programmes Maintenance and cleaning Cleaning the water inlet filter Emergency emptying out Something not working Spinning Display shows the alarmMachine vibrates when Door will not openReparirs After sales service 0870 01132 963 21/08