6 Display
The display shows the following information:
•duration of selected programme
•delayed start
•end of programme
•incorrect option selection
•alarm code
•Duration of selected programme
After you have selected the programme, its duration (in hours and minutes) appears on the display. It is calculated automatically on the basis of the maximum load accepted for each type of fabric and of the required degree of drying.
1.20
When the programme starts, the remaining time is displayed every 5 minutes.
•Delayed start
If you have selected a delay time by means of the relevant button, the display shows it for 2 seconds; then it shows the duration of the previously selected programme.
The countdown is displayed every 30 minutes until it displays “90 minutes” and then hour by hour.
3 
•End of programme
A flashing zero indicates the end of the programme and it is displayed after the
0
•Incorrect option selection
If you select an option that is not compatible with the programme you have selected, the display shows Err (error).
This code will reappear during the execution of the programme if you press one of the option buttons.
•Alarm code
In the case of a functional problem, the display shows an alarm code (e.g. E21). See page 13 for more detailed information.
E21
7 Start/Pause button
Press this button to start the dryer after having selected the programme and the options.
The relevant light will stop flashing. If you have chosen a delayed start, the machine will begin the countdown.
If the door of the appliance or the small door at the bottom is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted.
In both cases the light of the Start/Pause button flashes to remind you that the start button needs to be pressed again.
11