Something Not Working, Dry enough | John Lewis JLDV 02 specs

Something Not Working

If the tumble dryer is not working correctly, please carry out the following checks before contacting your local Service Force agent.

IMPORTANT: If the END light flashes, the buzzer sounds and an alarm code is displayed, switch the machine off and call the telephone number given below.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made even if the appliance is under guarantee.

Symptom

Solution

The tumble dryer does not start

• The door(s) has (have) not been closed.

• The plug is not properly inserted in the power socket.

• There is no current at the socket.

• The main fuse or the fuse in the plug has blown.

• The selector dial is not set correctly.

• The START/PAUSE Button has not been depressed.

• The DELAY START option has been selected.

Drying takes too long or laundry is not	•	The laundry has not been spun properly.
dry enough.	•	The laundry has not been spun properly.
dry enough.	•	The filters and are clogged.
	•	The filters and are clogged.
	• The room temperature is too high.
	•	The selected time or drying cycle was not suitable for
		the laundry.
	•	The LOW TEMPERATURE button has been pressed.
	•	There is too much laundry inside the appliance.
	•	The dryer is not correctly installed.

The drum light does not light up:	•	The Programme/Time selector dial is on position “OFF”.
	• The lamp is defective.