Speed Selection Chart Cutter Size | Craftsman 315.26921 instruction

ADJUSTING DEPTH OF CUT (WroTH ROUTER

See Figure 7.

The indicator point on the base can be used when using your router mounted to a router tame,

[] Set the cutter at zero depth of cut,

[] Rotate depth indicator ring to desired depth of cut on the scab, Refer to "ADJUSTING DEPTH OF

CUT" earlier in this manual

[] Tighten Hocking arm secureiy,

FOR ROUTER TABLE USE ONLY

INDICATOR

POINT

DEPTH

ADJUSTMENTRING

Fig, 7

ADJUSTING SPEED

See Figure 8.

Your router has a variabHe speed eontroHseHector designed to aHHowoperator controH of speed and torque iimits. You can make speed selections best suited to the type of cut, the materiai being cut, and the size of bit being used. The variabie speed controi selector allows you to adjust router speed from 15,000 to 25,000 RPM. There is a six-step scab (A to F) on the variabHe speed controH seHector. To increase the speed and torque of your router, turn the variable speed control selector to a higher setting (F). Turn to a lower setting to decrease speed and torque.

NOTE: If you do not want to use the variable speed

control selector, turn it to the highest possible setting, and the feature will not be active.

The speed selecfion chart shown gives suggested speed settings based on the diameter of the cutter and the type of materiai being routed,

We suggest that you practice with the variabie speed feature of your router before instaiHng a cutter and making cuts in wood,