Clean it with a brush and rinse it under the shower if necessary.
P0639 |
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser cabinet and in the inner part of the small door with a damp cloth.
Important! Do not use pointed objects or utensils to clean the spaces between the plates, as this could damage the condenser and make it permeable.
Do not use this appliance if the condenser has not been fitted.
The reservoir must be
If this is not done the pilot light FULL TANK comes on during next drying and the programme stops, leaving the laundry damp. The buzzer will sound.
After inserting the reservoir press the START/PAUSE button again to allow the programme to continue.
Handy tip: The condensed water may be used in a steam iron or to top up a battery, etc. In this case it must be filtered (e.g. through a coffee filter).
Cleaning the air intake grill
Using a vacuum cleaner remove the fluff from the air intake grill at the back of the appliance.
P1162 |
Emptying the water reservoir
Water extracted from the laundry condenses inside the machine and is collected in a reservoir.
The reservoir must be emptied after each drying cycle to ensure efficient operation when the machine is next used. The FULL TANK light reminds you to perform this operation.
Proceed as follows:
•Pull out the reservoir
•Turn it upside down and let water empty
•
Cleaning the drum
If the laundry is not drying to the level of dryness you have set, either too dry or too damp, we advise you to clean the inside of the drum with a cloth soaked in vinegar.
This will eliminate the slight residues of detergent and softeners used in the washing, or to any residues of lime contained in the water. A build up of these residues will prevent the sensors from correctly measuring the degree of dryness of the laundry.
P1156 |
P1157 |
17