Something not working
If the tumble dryer is not working correctly, please carry out the following checks before contacting your local Service Force agent.
IMPORTANT: if the END light flashes, the buzzer sounds and an alarm code is displayed, switch the machine off and call the telephone number given on page 21.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made even if the appliance is under guarantee.
Symptom | Solution | ||
|
|
| |
The tumble dryer does not start | • | The door(s) has (have) not been closed. | |
• | The plug is not properly inserted in the power socket. | ||
| |||
| • | There is no current at the socket. | |
| • | The main fuse or the fuse in the plug has blown. | |
| • | The selector dial is not set correctly. | |
| • | The water reservoir is full or not properly inserted (the | |
|
| FULL TANK light is on ). The programme starts in any | |
|
| case but it stops after approx. 4 minutes. | |
| • | The START/PAUSE Button has not been pressed. | |
| • | The DELAY START option has been selected. | |
|
|
| |
Drying takes too long or laundry is not | • | The laundry has not been spun properly. | |
dry enough. | • | The filters and/or the condenser are clogged. | |
| • | The water reservoir is full. | |
| • The room temperature is too high. | ||
| • | The selected time or drying cycle was not suitable for | |
|
| the laundry. | |
| • | The HALF POWER button has been pressed. | |
| • | There is too much laundry inside the appliance. | |
| • | The dryer is not correctly installed. | |
|
|
| |
The drum light does not light up: | • | The Programme/Time selector dial is on position “OFF”. | |
| • The lamp is defective. | ||
|
|
| |
19