SETTING UP
1.MAKE SURE THAT THE MACHINE RESTS ON ALL FOUR FEET ON A LEVEL SURFACE.Adjustable screws are provided at the bottom to allow levelling.
2.Loosen securing nut. Adjust the screw to change level. Tighten securing nut to ensure that screw is locked into place.
3.MACHINE SHOULD BE LEVELLED AGAIN IN C A S E IT IS MOVED TO A NEW SITE.
WATER INLET
1.Connect inlet hose to water tap/line.
2.Do not connect machine to a hot water supply.
WATER INLET |
DRAIN |
PIPE |
WATER OUTLET
1.A drain pump is provided in the machine to pump out used water.
2.The end of the outlet should be placed near a drain. If necessary, it can be placed over the edge of a sink at a maximum height of 1 mt. from the floor level.
3.Allow free flow of water from the outlet pipe.
DRAIN |
PIPE |
WATER INLET |
ELECTRICAL CONNECTION
1.Check that the electrical line can take the required load.
2.Connect to a 220V, 50 Hz single phase AC supply.
3.Machine must be earthed properly before operation. This can be done by using a 3 pin plug and properly earthed socket of 16 ampere rating.
4.Ensure that there is a firm connection between the 3 pin plug and socket, else it may result in sparking and subsequent failure of 3 pin plug.
5.Use of extension cord not recommended.
16 AMPS
X
X
5