Kenmore 110.4997, 110.4996 manual Location Requirements, Installation clearances, Washer Dimensions

Page 6

Location Requirements

Selecting the proper location for your washer improves performance and minimizes noise and possible washer “walk.”

Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. See “Drain System.”

Companion appliance location requirements should also be considered. Proper installation is your responsibility.

You will need

A water heater set to deliver 120°F (49°C) water to the washer.

A grounded electrical outlet located within 6 ft (1.8 m) of where the power cord is attached to the back of the washer. See “Electrical Requirements.”

Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).

A level floor with a maximum slope of 1" (2.5 cm) under entire washer. Installing the washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not recommended.

A sturdy and solid floor to support the washer with a total weight (water and load) of 400 lbs (180 kg).

Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.

Installation clearances

The location must be large enough to allow the washer door to be fully opened.

Additional spacing should be considered for ease of installation and servicing.

Additional clearances might be required for wall, door, and floor moldings.

Additional spacing of 1" (2.5 cm) on all sides of the washer is recommended to reduce noise transfer.

Companion appliance spacing should also be considered.

Washer Dimensions

27"

50¹⁄₂" (68.6 cm)

(128.3 cm)

38"

(96.5 cm)

31¹⁄₂"

(80.0 cm)

Recommended installation spacing for custom undercounter installation

The dimensions shown are for the recommended spacing.

Custom undercounter installation - Washer only

39" min. (99.0 cm)

1"

 

27"

 

1"

(2.5 cm)

(68.6 cm)

(2.5 cm)

Recommended installation spacing for recessed or closet installation, with or without a pedestal

The dimensions shown are for the recommended spacing.

Recessed area or closet installation

 

 

 

 

3"

 

 

 

 

(7.6 cm)

 

 

34"

48 in.2 *

 

 

(86.4 cm)

(310 cm2)

 

 

 

 

24 in.2 *

3"

 

 

 

(155 cm2)

 

 

 

 

(7.6 cm)

1"

31¹⁄₂"

4"

 

 

(2.5 cm)

(80 cm)

(10.2 cm)

 

 

A

 

 

B

A. Side view - closet or confined area

B. Closet door with vents

*Min. top and bottom air openings for closet door.

Recessed or closet installation - Washer on pedestal

 

 

 

 

18" min.

 

 

 

 

 

(45.7 cm)

 

1"

27"

1"

1"

31¹⁄₂"

4"

(2.5 cm)

(68.6 cm)

(2.5 cm)

(2.5 cm) (80 cm) (10.2 cm)

 

A

 

 

B

 

A. Recessed area

B. Side view - closet or confined area

6

Image 6
Contents Front-Loading Automatic Washer Table of Contents Kenmore Elite Appliance Warranty ONE Year Limited WarrantyWasher Safety Your safety and the safety of others are very importantInstallation Requirements Tools and PartsOptions Installation clearances Washer DimensionsLocation Requirements Standpipe drain system wall or floor views a & B Recommended installation spacing for cabinet installationDrain System Laundry tub drain system view aElectrical Requirements Grounding InstructionsInstallation Instructions Remove Transport SystemConnect the Inlet Hoses Level the Washer Route the Drain HoseSecure the Drain Hose Floor drainComplete Installation Starting Your Washer Using the Proper DetergentWasher USE First Wash Cycle Without LaundryTo fill dispenser compartments Using the DispenserChoosing the Right Detergent Main Wash detergent compartmentPausing or Restarting Status LightsCycles Normal Washer Sounds My Cycle Delay StartCycle Signal Normal RinseWash Temp ModifiersLaundry Guide Auto Temp ControlPreparing clothes for washing Laundry TipsLoading SortingCleaning Your Washer Washer CareWater Inlet Hoses Vacation, Storage, and Moving CareWasher won’t fill, wash or rinse TroubleshootingWasher won’t start Washer stopsWater near washer Washer won’t drain or spinWasher makes noise or vibrates Dispensers clogged or leakingGray whites, dingy colors Stains on loadLoad is wrinkled Cycle too long461970235731