Kenmore 110.4996, 110.4997 manual Drain System, Standpipe drain system wall or floor views a & B

Page 7

Recommended installation spacing for recessed or closet installation, with stacked washer and dryer

The dimensions shown are for the recommended spacing.

48 in.2 *

(310 cm2)

3" (7.6 cm)

 

 

 

3" (7.6 cm)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

24 in.2 *

 

 

 

 

 

 

 

 

 

 

 

 

 

1" (2.5 cm)

 

 

 

 

 

 

 

 

 

 

 

 

(155 cm2)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6" (15.2 cm)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

76" (193 cm)

5½"**

 

 

 

1"***

 

 

 

27"

 

 

 

1"***

 

 

 

 

 

 

(14 cm)

 

 

 

(2.5 cm)

 

 

(68.6 cm)

 

(2.5 cm)

*Min. top and bottom air openings for closet door.

**External exhaust elbow requires additional space.

***Wall, door and floor molding may require additional spacing.

Drain System

The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. Select the drain hose installation method you need. See “Tools and Parts.”

Standpipe drain system - wall or floor (views A & B)

The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The minimum carry-away capacity can be no less than 17 gal. (64 L) per minute.

The top of the standpipe must be at least 30" (76.2 cm) high and no higher than 96" (2.4 m) from the bottom of the washer.

30" min. (76.2 cm)

AB

Laundry tub drain system (view A)

The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 30" (76.2 cm) above the floor.

Floor drain system (view B)

The floor drain system requires a siphon break that may be purchased separately. See “Tools and Parts.”

The siphon break must be a minimum of 28" (71 cm) from the bottom of the washer. Additional hoses might be needed.

28" min.

Recommended installation spacing for cabinet installation

30" min. (76.2 cm)

(71 cm)

The dimensions shown are for the recommended spacing.

For cabinet installation, with a door, the minimum ventilation openings in the top are required.

7" (17.8 cm)

7" (17.8 cm)

9"

(22.9 cm)

4"

31½"

1"

1"

27"

1"

(10.2 cm)

(80.0 cm)

(2.5 cm) (2.5 cm) (68.6 cm)

(2.5 cm)

AB

7

Image 7
Contents Front-Loading Automatic Washer Table of Contents ONE Year Limited Warranty Kenmore Elite Appliance WarrantyYour safety and the safety of others are very important Washer SafetyTools and Parts Installation RequirementsOptions Washer Dimensions Installation clearancesLocation Requirements Laundry tub drain system view a Recommended installation spacing for cabinet installationDrain System Standpipe drain system wall or floor views a & BGrounding Instructions Electrical RequirementsRemove Transport System Installation InstructionsConnect the Inlet Hoses Floor drain Route the Drain HoseSecure the Drain Hose Level the WasherComplete Installation First Wash Cycle Without Laundry Using the Proper DetergentWasher USE Starting Your WasherMain Wash detergent compartment Using the DispenserChoosing the Right Detergent To fill dispenser compartmentsStatus Lights Pausing or RestartingCycles Normal Washer Sounds Normal Rinse Delay StartCycle Signal My CycleAuto Temp Control ModifiersLaundry Guide Wash TempSorting Laundry TipsLoading Preparing clothes for washingWasher Care Cleaning Your WasherVacation, Storage, and Moving Care Water Inlet HosesWasher stops TroubleshootingWasher won’t start Washer won’t fill, wash or rinseDispensers clogged or leaking Washer won’t drain or spinWasher makes noise or vibrates Water near washerCycle too long Stains on loadLoad is wrinkled Gray whites, dingy colors461970235731