TROUBLESHOOTING
First try the solutions suggested hers and possibly avoid the cost of a service call...
NOTE: Washer will not operate with the lid open.
Noisy
Is the load balanced, and is the washer level? The wash load should be balanced and not overloaded, The washer must be level, The front feet should be properly installed and the nuts tightened. Reset the rear leveling legs (if needed). See the Installation Instructions.
•Did you completely remove the yellow shipping strap with cotter pins? See the Installation Instructions.
•Are the gears engaging after the drain and before spin, or is the upper part of agitator clicking during wash? These are normal washer noises.
Is water deflecting off the tub ring or the load? Center the
tub before starting the washer. The wash load should be balanced and not overloaded. The fill or spray rinses can deflect off the load. The washer must be level. The front feet should be properly installed and the nuts tightened. Reset the rear leveling legs (if needed). See the Installation Instructions.
•Check household plumbing for leaks.
Basket crooked
•Was the washer basket pulled forward during loading? Push the basket to the center before starting wash.
Is the load balanced, and is the washer level? The wash load should be balanced and not overloaded. The washer
Leaking
•Checkthe following: Are the fill hoses tight?
Are the fill hose washers properly seated?
must be level. The front feet should be properly installed and the nuts tightened. Reset the rear leveling legs (if needed). See the Installation Instructions.
•The washer basket moves while washing. This is normal.
Is the drain hose clamp properly installed? See the Installation Instructions.
•Is the sink or drain clogged? Sink and standpipe must be able to handle 17 gal. (64 L) of water per minute.
Agitator operation
•The top of the agitator is loose, or moves in only one direction. This is normal.
NEW VEND PRICE
To change vend price, detach and mail the lower portion to:
Customer Service Department
Greenwald Industries Inc.
212 Middlesex Ave.
Chester, CT 06412
The coin chute has been preset at the factory.
When increasing in $.25 pricing
Follow product information instructions; no extra parts required.
When decreasing in $.25 pricing - or - changing to &10 pricing
(Coin sizing block required; see "Changing Vend Price" section.)
Order required parts using this
Quantity
Existing Vend Price
New Vend Price
Name
Company
Address
City
Daytime phone
Purchase date
13