Using the 30 Day Detergent Dispenser
(select models)
Filling Dispenser
1)Unscrew the dispenser fill cap (figure 1).
2)Pour in your favorite liquid detergent, up to 100 fluid ounces at one time.
3)Replace the dispenser fill cap.
4)Close the washer lid.
5)Open the washer lid.
6)Move the slide indicator all the way to the top (fig- ure 1). Next, follow steps 7 and 8 to set the amount of detergent used for the average load.
Note: Steps 7 and 8 only need to be done ONCE when first filling the dispenser or changing brands of detergent.
7)Place the cap of your detergent bottle under the “PUSH” button. Fill the cap with detergent from the dispenser as full as you would for most of your loads by pressing and holding the “PUSH” button (figure 2). Place the detergent from the cap either in the tub or back in the dispenser by removing the dispenser fill cap.
8)Move the slide indicator to the level of the liquid in the sight glass (figure 3). For your next load of laundry, just press and hold the “PUSH” button until the detergent moves down to the slide indica- tor to dispense detergent directly into the tub.
9)The sight glass on the right side shows how much detergent remains in the dispenser. Refill the dis- penser when the detergent level nears the bottom of the refill indicator window.
Note: If you decide to change brands of liquid deter-
gent (Example: Tide® to Wisk® or Tide with Bleach Alternative® to Tide®) it is important the dispenser be empty and clean before adding new detergent (see page 7). Different detergents may interact and clog the dispenser.
Figure 1
Figure 2
Figure 3
6