Whirlpool TAWM400A Operating Your, Washer, Before starting your washer, Selecting a load size

Operating Your

	In This		Section
I	Before	stating		your	wuher	5
	Starting	or stopping			your waahw	.5
	Meeting		a load	size	..........................................	5
	Selecting		wash-rinse		temperatures	.6

Washer

Selecting a cycle			and	time	.6
Using	rinse nd		l ptn		.6
Uoing	drain	and	spin		6
What	happen.	in	each	cyck	.9

Operating your washer properly assures maximum washing efficiency. This section gives you important information to help you to select a cycle, time, and temperature for your wash load.

Before starting your washer

Add measured detergent. Then place a sorted load in the washer before starting. See page 11 for additional “Beforeyou wash” information.

NOTE: If your washer has a Consumer Buy Guide, remove it and place it with your Use and Care Guide.

Starting or stopping your washer

Starting your washer:

1.Push in the Cycle Control Knob and turn it clockwise. Stop when the indicator on the knob’s outer ring points to the number in the wash cycle you want. The numbers are minutes of wash time.

2.Select a load size and a water temperature.

3.Pull out the Cycle Control Knob.

Stopplng and rsstartlng your washer:

lTo stop the washer at any time, push in the Cycle Control Knob.

lTo restart the washer, close the lid (if necessary) and pull out the Cycle Control Knob.

Selecting a load size

Position the Load Size Selector at the setting that corresponds to the size load you want to wash.

Select a load size based upon the size of the load and the fabric you are washing. See page 11 for additional loading information.

To change the load size setting after the washer has started to fill, move the Selector to the desired new setting.

5