Whirlpool 3953964 manual Washer basket is crooked Load is tangled or twisted, Load too wet

Washer basket is crooked Load is tangled or twisted

■Was the washer basket pulled forward during loading? The wash load should be balanced and not overloaded. Push the basket to the center before starting washer.

■Is the load balanced and the washer level?

The wash load should be balanced and not overloaded.

The washer must be level. The front feet should be properly installed and the nuts tightened. Reset the rear leveling legs (if needed). See the Installation Instructions.

■The washer basket moves while washing. This is normal.

Load too wet

■Your washer uses cold rinse water.

Cold rinses leave loads wetter than warm rinses.

Residue or lint on load

■Did you sort properly?

Sort lint givers (towels, chenille) from lint takers (corduroy, synthetics). Also sort by color.

■Did you overload the washer?

The wash load must be balanced and not overloaded. Lint can be trapped in the load if overloaded. Wash smaller loads.

■Check the following:

Was paper or tissue left in the pockets?

Did you use enough detergent? Follow manufacturer’s directions. Use enough detergent to hold the lint in the water.

Is your water colder than 70°F (21°C)? Wash water colder than 70°F (21°C) may not completely dissolve the detergent.

Stains on load

■Did you follow the manufacturer’s directions when adding detergent and fabric softener?

Measure detergent and fabric softener. Use enough detergent to remove soil and hold it in suspension.

Dilute fabric softener and add to the rinse portion of a cycle only. Do not drip fabric softener on clothes.

■Is there above average iron (rust) in water? You may need to install an iron filter.

■Did you properly sort the load?

Sort dark clothes from whites and lights.

■Did you unload the washer promptly?

To avoid dye transfer, unload the washer as soon as it stops.

Load is wrinkled

■Did you unload the washer promptly? Unload the washer as soon as it stops.

■Did you overload the washer?

The wash load must be balanced and not overloaded. Loads should move freely during washing.

■Was the wash water warm enough to relax wrinkles? If safe for the load, use warm wash water.

■Are the hot and cold water hoses reversed?

Check to be sure the hot and cold water hoses are connected to the right faucets. See the Installation Instructions.

■Did you overload the washer?

The wash load must be balanced and not overloaded. Loads should move freely during washing.

■Did you wrap items around the agitator?

Drop items loosely into the washer. Do not wrap items around the agitator.

Gray whites, dingy colors

■Did you properly sort the load?

Dye transfer can occur when mixing whites and colors in a load. Sort dark clothes from whites and lights.

■Was the wash temperature too low? Use warm washes if safe for the load.

■Did you use enough detergent, or do you have hard water?

Use more detergent for washing heavy soils in cold or hard water.

■Are the hot and cold water hoses reversed?

Check to be sure the hot and cold water hoses are connected to the right faucets. See the Installation Instructions.

Garment damage

■Check the following:

Were sharp items removed from pockets before washing? Empty pockets, zip zippers, snap or hook fasteners before washing.

Were strings and sashes tied to prevent tangling?

Were items damaged before washing? Mend rips and broken threads in seams before washing.

■Did you overload the washer?

Loads should move freely during washing.

■Did you properly add chlorine bleach?

Do not pour chlorine bleach directly on load. Wipe up bleach spills. Undiluted bleach will damage fabrics.

■Did you follow the manufacturer’s care label instructions?

10