Whirlpool 3950310 warranty Sequence of cycles, Wash, Rinse

Page 11

OPERATING YOUR WASHER

UNDERSTANDING WHAT HAPPENS IN EACH CYCLE

When the Cycle Control knob is set to a number and pulled out, the washer fills (to the selected load size) before agitation and timing start. The washer begins agitating immediately after filling; agitation occurs with the washer lid up or down.

During agitation, the XTRA ROLL ACTION* agitator creates a continuous rollover action that pro-

vides a thorough cleaning of the wash load.

After agitation starts, the Cycle Control knob turns clockwise until it points to an Off area and the cycle ends.

NOTE: The washer pauses briefly throughout each cycle. These pauses are normal for washer operation.

Sequence of cycles

WASH

Fill

Wash selected time

Drain

No agitation

Spin

The Permanent Press cycle partially drains, fills, agitates briefly, and drains.

RINSE

Fill

Rinse

Drain-No agitation

Spin-Spray rinse

Spin

Off

11

Image 11
Contents 3950310 Automatic washersPlease record your modelÕs information Thank you for buying a WHIRLPOOL* applianceYour safety and the safety of others is very important Washer SafetyTemperature Cycle signal Parts and FeaturesOn next Using Your WasherOperating Your Washer Super Capacity Plus Washers LoadingSelecting a Cycle and Time Loading suggestionsCycle Descriptions Delicate cycle Model LSR8300 Normal cycleHeavy cycle RINSE/DRAIN and Spin Rinse Sequence of cyclesWash Cleaning the liquid fabric softener dispenser Cleaning Your WasherCleaning the exterior Cleaning the interiorProblem Cause Solution TroubleshootingCommon Washing Problems Troubleshooting Common Washing Problems Common Washing Problems Our consultants provide assistance with If YOU Need Replacement PartsGearcase assembly covered by your warranty For Further AssistanceToll free, 830 a.m. 6 p.m. EST, at If you need service†Topic IndexFor information in Canada For assistance or service in Canada