Washing a Load of Laundry
WASHING CLOTHES MANUALLY
You can wash clothes manually without using the Fuzzy Logic feature. To do so:
1.Turn on the water at the water source sink.
2.Press the 
(On/Off) button on the washing machine.
3.Open the door.
4.Load the articles one at a time loosely into the drum, without overfilling.
5.Close the door.
6.Put the detergent and, if necessary, softener or chlorine bleach, in the appropriate compartments.
7.Press the Wash/Rinse Temperature button to select the water temperature (Warm/Cold➔ Warm/Warm➔ Hot/Cold ➔ Cold/Cold )
8.Press the Spin button to select the spin speed, [no, rh, 400, 600, 800, 900 and 1000, 1100 revolutions per minute(rpm)].
Note: The rinse hold program allows you to take clothes that are dripping wet out of the washing machine.
no : No Spin, rh : Rinse Hold.
9.Press the Extra Rinse button to select the Extra Rinse (if needed).
10.Press the Start/Pause button and the machine will begin the cycle.
When the cycle is finished:
1.Open the door.
Note: The door will not open until 3 minutes after the machine stops or the power turns off.
2.Remove laundry.
USING DELAY START
You can set the washing machine to start your wash automatically at a later time, choosing from a 1 to a 24 hour delay (in 1 hour increments).
To do this:
1.Manually or automatically set your washing machine for the type of clothes you are washing.
2.Press the Delay Start button repeatedly until the delay time is set.
3.Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin counting down until it reaches your start time.
4.To cancel Delay Start, press the 
(On/Off) button, then turn the washing machine on again.
12 SAMSUNG Washing Machine Owner’s Instructions