Samsung SW68ASP, SW57APP Installation &MAINTENANCE, Environment, Case of PUMP-DRAINED Washer

Page 5

INSTALLATION &MAINTENANCE

ENVIRONMENT

Leave some space.

Maintain at least 10cm between the washer and the wall.

Place the washer on a sturdy flat surface.

If the washer is placed on an uneven or weak surface, noise and vibration can occur (allowable slope is 1 degree)

IN CASE OF PUMP-DRAINED WASHER

Take out the Be sure to join tightly

Install the drain

cap-hose and

the drain hose into the

hose in the position

connect the

drain-outlet on the left

of about 70~80cm

outlet-hose

side of the machine.

above the ground.

Never install the washer in a very steamy environment or where it might be open to the rain.

Excessive moisture may cause an electrical shock hazard.

Avoid direct sunlight or heaters.

As plastic and electrical components are affected by direct heat,never place the washer near furnaces, boilers,etc.Do not place under direct sunlight.

HOW TO CONNECT WATER SUPPLY HOSE

Check the type of tap fitting which is in your laundry and then see appropriate instruction below:

A tap of ordinary type is desirable

In case of square tap

 

 

Take out the internal part of the connector

 

 

and join it in the following way.

 

 

Internal part

ORDINARY TAP SQUARE TAP

ROTATING TAP

 

1.Remove the adaptor from the

 

4.Connect the water supply hose to

water supply hose.

 

the adaptor. Pull down the part

 

 

(c) of the water supply hose .

 

 

When you release part (c) the

 

 

hose is automatically connects to

 

 

the adaptor making a 'click' sound.

2. First,using a "+" type screw

 

5. Connect the other end of the water

driver, loosen the four screws on

 

supply hose to the inlet water valve

the adaptor.

 

at the top of the washer.

Next,take the adaptor and

 

Screw the hose clockwise all the

turn part(b) following the

 

way in.

arrow for gap about 5mm

 

 

between them.

 

 

3. Connect adaptor to the water

 

6. If the water tap is a screw type,

tap by tightening the screws

 

assemble a water supply hose that

firmly.

 

fits to the tap as shown.

Then,turn part (b) following

 

 

the arrow and put (a) and

 

 

(b)together.

 

 

Note : The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be used.

4

SW68ASP-02290A-EN.indd 4

2006-08-21 ¿ÀÈÄ 8:33:11

Image 5
Contents Control Panel Washing Instruction Washing Program Optional Cycle Troubleshooting SpecificationEcono Wash course FeaturesDescriptionofparts Safetyinstructions HOW to Connect Water Supply Hose Installation &MAINTENANCEEnvironment Case of PUMP-DRAINED WasherHOW to ADD the Detergent HOW to Clean the FilterHOW to ADD the Fabric Softener LevellingTo do a Clean Washing PrecautionsWhen using an extension cord and a boosting transformer Never make an earthing toControlpanel Wash Program ProcedureWashinginstruction Optionalcycle WashingprogramWashing machine won’t work TroubleshootingSpinning does not work Water does not drainSW68ASP-02290A-EN.indd 2006-08-21 ¿ÀÈÄ