HOW TO CLEAN THE FILTER
Clean the filter net often to keep the washer clean.
CLEANING THE FILTER (pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the
3.Take out the filter and remove any sludge.
4.Reassemble in reverse order.
1. Push the upper | 2. Open the cover | 3. Clean the filter. 4. Close the cover and |
part of the filter | as shown in the | insert the lower part |
and pull in. | figure. | of the filter in the |
|
| basket first and then |
|
| push the filter with |
|
| "click" sound . |
HOW TO ADD THE DETERGENT
1. Open the detergent box
by pulling in the direction of the arrow as shown in the figure.
2. Add the amount of detergent for one washing evenly in the box so that the detergent does not overflow the box.
HOW TO ADD THE FABRIC SOFTENER
When a proper amount of fabric softener is stored in the box, it is automatically added in at the final rinse cycle.
In case the hot water only is connected, this function will not be operated.
LEVELLING
1.Pull down the adjusting handles of the adjusting feet which are located at the right and left of the front side.
2.Adjust the height of the machine upwards or downwards.
3.When the adjustment is finished, push back the handles to fix the adjusting feet.
Note
Do not kick or step on the adjusting handles.
When too much softener is stored above the base line, it may not be operated properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.
Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure.
Place the machine more than 10cm away from the wall.
5