Samsung Silver Care Washer owner manual Important to Installer, Step, Removing the Shipping Bolts

Page 8

Installing Your Washer

IMPORTANT TO INSTALLER

Please read the following instructions carefully before installing your Washer. These instructions should be retained for future reference

STEP 1

Removing the Shipping Bolts

Before using your Washer, you must remove the four shipping bolts from the back of the unit.

1. Loosen all bolts with the supplied spanner.

2.Slide the bolt and spacer up and remove the bolt with spacer through the hole in the rear wall of your Washer.

Repeat for each bolt.

3. Fill the holes with the supplied plastic covers.

4. Keep the shipping bolts and spacers for future use.

STEP 2

Selecting a Location

Before you install your Washer, make sure the location:

•Has a hard, level surface

•Is away from direct sunlight

•Has adequate ventilation

•Will not be freezing (below 32°F or 0°C)

•Is away from heat sources such as coal or gas

•Has enough space so that your Washer need not stand on its power cord

•Doesn’t have any carpeting that will obstruct ventilation openings.

STEP 3

Installing your Washer

1.Place the drain hose in the drain facility. Be sure an airtight connection is NOT made between the drain hose and the standpipe.

Standpipe must be at least 18 in or 46 cm high.

NOTE: Caution must always be exercised to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way – by elbows, couplings, or excessive lengths. For situations where the drain hose cannot be conveniently elevated to at least 18 in or 46 cm, the drain hose must be supported.

2.Check the inlet hose to ensure a washer is inside each fill hose. Thread the inlet hoses to the HOT and COLD faucet connections. On the other end of the hose, check for one rubber washer per hose and install each fill hose to the water valve. Make sure the hose with the red line is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers.

NOTE: For correct water use, connect both HOT and COLD water valves. If one is not connected,“nF” (no fill) error can occur.

LAUNDRY TUB

STAND PIPE

 

HOSE

96” MAX.

RETAINER

 

18” MIN.

 

TIE

 

STRAP

96” MAX.

 

18” MIN.

A-4 SAMSUNG Clothes Washer Owner’s Instructions

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Samsung SilverCare Register your product at Code No. DC68-02346B-ENSafety Precautions Important Safety SYMBOLS, WORDS, LabelsDo not sit on top of your Washer Table of Contents Installing Your Washer Unpacking Your WasherOverview of Your Washer Samsung Clothes Washer Owner’s Instructions A-1Water Basic Location RequirementsGrounding Alcove or Closet Installation Minimum Clearances for Closet and Alcove InstallationsDrain Facility FlooringImportant to Installer Installing your WasherStep Removing the Shipping BoltsInstalling Your Washer Operating Instructions Loading Your WasherGetting Started Washing a Load of Laundry Overview of the Control PanelTemperature selection button Signal selection buttonDigital graphic display Spin selection buttonPower button Select Cycle OptionCycle Selector Start/Pause selection buttonChild Lock Garment +MY Cycle ACTIVATING/DEACTIVATINGFor Silvercare Washing Features Detergent USEAutomatic Dispenser Detergent CompartmentPRE Wash Compartment Select Models Bleach CompartmentFabric Softener Compartment Liquid chlorine bleach onlyCleaning the Exterior Cleaning the InteriorCleaning the Dispensers Maintaining Your WasherTroubleshooting Check These Points if Your WasherMake sure temperature selection is correct Recovery rateTemperature. This is normal Temperature control feature as your Washer determinesInformation Codes Problem with control Call for service. See below Call for serviceTemperature sensor problem Restart the cycle Vibration sensor problem Restart the cycleFabric Care Chart AppendixSpecification Protecting the EnvironmentDeclaration of Conformity This appliance complies with UL2157Cycle Chart 326LAS 306LAW, 306BAW Samsung Clothes Washer Owner’s Instructions F-4316LAW, 316LAS, 316BAW, 316HAC Samsung Clothes Washer Owner’s Instructions F-6 To obtain warranty service, please contact Samsung at Memo Samsung Clothes Washer Owner’s Instructions F-8

Silver Care Washer specifications

The Samsung Silver Care Washer is a groundbreaking laundry appliance designed to enhance convenience, efficiency, and hygiene in the washing process. Featuring an innovative combination of advanced technologies and intuitive design, it offers users numerous benefits that make laundry day less of a chore.

One of the standout features of the Samsung Silver Care Washer is its unique silver ion technology. This technology effectively utilizes the antimicrobial properties of silver to eliminate up to 99.9% of bacteria and germs during the wash cycle. This is particularly beneficial for households with young children or individuals with allergies and sensitivities, ensuring that clothing, bedding, and towels come out not just clean but also hygienic.

Another significant feature is the EcoBubble technology, which allows users to wash clothes in cold water while still achieving optimal cleaning results. By generating bubbles that penetrate fabric effectively, this technology reduces energy consumption and helps preserve the colors and textures of garments. This environmental aspect aligns with the growing trend towards sustainable living, making the Samsung Silver Care Washer a responsible choice for eco-conscious consumers.

The washer also comes equipped with a large capacity drum, accommodating heavy loads and bulky items, such as blankets and comforters. This design ensures that families can complete laundry tasks more efficiently without needing to do multiple loads. The diamond drum pattern further protects fabrics by minimizing snags and fraying, extending the life of garments.

Additionally, the washer features a self-cleaning cycle that eliminates dirt and detergent residues in the drum, enhancing hygiene and reducing the need for manual cleaning. Smart functions such as Wi-Fi connectivity allow remote control and monitoring through a dedicated app, making it easier than ever to manage laundry from anywhere.

Operating with a quiet but powerful motor, the Samsung Silver Care Washer is designed for minimal noise disruption, ensuring peaceful laundry processes. The combination of intuitive controls, various wash cycles, and energy-efficient operations makes it not only user-friendly but also a wise investment for modern households seeking a reliable and effective laundry solution.

In conclusion, the Samsung Silver Care Washer combines advanced technologies, capacity, and eco-friendly features, providing a comprehensive laundry solution that focuses on performance, hygiene, and user convenience. It stands as a testament to Samsung's commitment to innovative home appliances, making life easier for users while promoting a cleaner and healthier home environment.
Top Page Image Contents