Samsung SW55APP2 manual Installation & Maintenance, Environment, HOW to Connect Water Supply Hose

Page 4

INSTALLATION & MAINTENANCE

ENVIRONMENT

Leave some space.

Maintain at least 10cm between the washer and the wall.

Place the washer on a sturdy flat surface.

If the washer is placed on an uneven or weak

surface, noise and vibration can occur (allowable slope is 1 degree)

Never install the washer in a very steamy environment or where it might be open to the rain.

Excessive moisture may cause an electrical shock hazard.

Avoid direct sunlight or heaters.

As plastic and electrical components are affected

by direct heat,never place the washer near furnaces, boilers,etc.Do not place under direct sunlight.

In case of pump-drained washer

Take out the

Be sure to join tightly

Install the drain

cap-hose and

the drain hose into the

hose in the position

connect the

drain-outlet on the left

of about 70~80cm

outlet-hose.

side of the machine.

above the ground.

cap-hose

outlet-hose

HOW TO CONNECT WATER SUPPLY HOSE

Check the type of tap fitting which is in your laundry and then see appropriate instruction below:

A tap of ordinary type is desirable

In case of square tap

 

Take out the internal part of the connector

 

and join it in the following way.

Internal part

ORDINARY TAP

SQUARE TAP

ROTATING TAP

1.Remove the adaptor from the

4.Connect the water supply hose to

water supply hose.

the adaptor. Pull down the part

 

(c) of the water supply hose .

 

When you release part (c) the

 

hose is automatically connects to

 

the adaptor making a 'click'

 

sound.

2.First,using a "+" type screw

5.Connect the other end of the

driver, loosen the four screws

water supply hose to the inlet

on the adaptor.

water valve at the top of the

Next,take the adaptor and

washer.

turn part(b) following the

Screw the hose clockwise all

arrow for gap about 5mm

the way in.

between them.

 

3. Connect adaptor to the water

6.If the water tap is a screw

tap by tightening the screws

type,assemble a water

firmly.

supply hose that fits to

Then,turn part (b) following

the tap as shown.

the arrow and put (a) and

 

(b)together.

 

4

Image 4
Contents Features Reciprocating mini agitator imitates hand wash actionDescription of Parts Dispenser SeeSafety Instructions Panel damaged or malfunction may occurInstallation & Maintenance HOW to Connect Water Supply HoseEnvironment Tap of ordinary type is desirable Case of square tapCleaning the Filter NET To do a Clean Washing ProcedureClose the lid Press power button Washing InstructionWashing Program Wash ProgramSensor Program Heavy Duty Program Econo Wash Program Wool ProgramTroubleshooting Delay StartWash only Rinse only Soak Drip DRYSpecification If YOU Need Help with Your NEW Samsung Washing MachineOwner’s Instructions