Cleaning the Filter NET

If the filter net is clogged after washing, lift up the net Remove the collected lint and rinse the filter net.

HOW TO ADD THE DETERGENT

1. Open the detergent box

by pulling in the direction of the arrow as shown in the figure.

2. Add the amount of detergent for one washing evenly in the box so that the detergent does not overflow the box.

HOW TO ADD THE FABRIC SOFTENER

●When a proper amount of fabric softener is stored in the box, it is automatically added in at the final rinse cycle.

❋In case the hot water only is connected, this function will not be operated.

❋When too much softener is stored above the base line, it may not be operated properly.

Only For models with polypropylene(plastic) wash bowl

●When the manufacturer’s recommended amount per load of fabric softener is stored in the softener inlet, it will be automatically dispensed during the final rinse cycle.

❋Before operating the washing machine, make

sure that any water remaining in softener dispenser from a previous load is removed.

CLEANING THE FILTER (pump drained washer)

1. Place a rag under washer filter not to wet the floor.

2. Turn the filter-cap to the left.

3. Take out the filter and remove any sludge.

4. Reassemble in reverse order.

LEVELLING

1. Pull down the adjusting handles of the adjusting feet which are located at the right and left of the front side.

2. Adjust the height of the machine upwards or downwards.

3. When the adjustment is finished, push back the handles to fix the adjusting feet.

NOTE

Do not kick or step on the adjusting handles.

SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.

●Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure.

●Place the machine more than 10cm away from the wall.