Samsung Q1044, Q844, Q1244 manual Connecting the water supply hoseOption, Positioning the drain hose

Installing the Washing Machine

Connecting the water supply hose(Option)

1. Remove the adaptor from the water		4. Connect the water supply hose to
supply hose.		the adaptor. Pull down part (c) of the
	c	water supply hose. When you
		release part (c) the hose automa-
		tically connects to the adaptor
		making a ’click’ sound.
2. First, using a “+” type screw driver,		5. Connect the other end of the water
loosen the four screws on the		supply hose to the inlet water valve
adaptor. Next, take the adaptor		at the rear of the washer. Screw the
and turn part(b) following the		hose clockwise all the way in.
arrow until there is a 5mm gap.
3. Connect adaptor to the water tap by
tightening the screws firmly.	a
Then, turn part (b) following the
arrow and put(a) and (b) together.	b

NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use the most conventional type of faucet for water supply. In case the faucet is square or too big, remove the spacing ring before inserting the faucet into the adaptor.

Positioning the drain hose

The end of the drain hose may be positioned in three ways:

Over the edge of a wash basin.

The drain hose must be placed at a height of between 60 and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece of string to prevent the drain hose from moving.

ln a sink drain pipe branch

The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60 cm above the ground.

ln a drain pipe

Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm and no longer than 90 cm.

SAMSUNG Washing Machine Owner’s Instructions 5