Samsung DC68-01518Q user manual Connecting the Water Supply Hose, Case of COLD-HOT Water Washer

Page 9

CONNECTING THE WATER SUPPLY HOSE

1.Remove the adaptor from the water supply hose.

5.Connect the other end of the water supply hose to the inlet water valve at the back of the washer.

Screw the hose clockwise all the way in.

2.First,using a "+" type screw driver, loosen the four screws on the adaptor.

Next,take the adaptor and

turn part(b) following the arrow for gap about 5mm between them.

a

b

5-1.Connect the other end of the water supply hose to the inlet water valve at the top of the washer.

Screw the hose clockwise all the way in.

3.Connect adaptor to the water tap by tightening the screws firmly.

Then, turn part (b) following the arrow and put (a) and (b)together.

a

b

If the water tap is a screw type,assemble a water supply hose that fits to the

tap as shown.

4. Connect the water supply hose to the adaptor. Pull down the part (c) of the water supply hose .When

the part (c)is released, the hose c is automatically connected to the adaptor making a 'click' sound.

NOTICE After completing connection, if water leaks from the hose, then repeat the same steps.

Use the most conventional type of faucet for water supply. In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.

IN CASE OF COLD-HOT WATER WASHER

hot

If you use only cold water inlet hose,

cold

 

you must fit the cap to the hot water

 

inlet valve as following.

cap

LEVELLING If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.

SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.

Open the lid of the machine, pour water into the tub up to the level

just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as

shown in the figure.

Place the machine more

than 10cm away from the wall.

Adjust the legs on feet

Adjustment the heigt of the machine

Adjust the legs to level the washer

Be careful not to put in your hand under the legs.

Pull the handles located at the right and left of the front side and slide off.

Adjust the height of the machine upward or downward.

When the adjustment

is finished, push the handles to fix the adjusting legs.

WATER SUPPLY CONNECTOR FILTER

1.Pull out the filter and wash well.

inlet water valve

2.Pull in the filter and connect the hose to the inlet water valve tightly.

3.Check if there is a leakage. Note to tighten up the connector.

8

Image 9
Contents Troubleshooting Specifications Installation & MaintenanceFeatures Safety Instructions Filter Spin Basket Power Cord Ground LeadPulsator Front Control Panel LIDControl Panel Washing Procedure Delay Start CourseClose the lid Manual Functions HOW to Assemble the Legs Installation & MaintenanceConnecting the Drain Hose Assembling the Prat Protection PanelWater Supply Connector Filter Connecting the Water Supply HoseAdjustment the heigt of the machine Case of COLD-HOT Water WasherHOW to Clean the Filter HOW to PUT the Detergent in and ADD the Fabric SoftenerDetergent Device Softener DeviceIs the drain hose clogged? TroubleshootingCase the Need for Servicing Arises