HOW to Clean the Filter, Detergent Device

HOW TO PUT THE DETERGENT IN AND ADD THE FABRIC SOFTENER

1.Open the detergent box by pulling in the direction of the arrow as shown in the

figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent	may not brim over the box.
Detergent Device	Softener Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline

•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.

•Do not use detergent, bleach or starch into the Softener Inlet.

•Using too much softener may produce unsatisfactory results.

•Do not open the lid during the Spin Dry cycle.

If added too early, its effectiveness will decrease.

•Do not leave the softener into the Softener Dispenser for a long time. Because softner became stiff.

CAUTION : If softener is stored over the above base line, it may flow down at any time.

1. Place a rag under the washer filter not to wet the floor.	(pump drained washer)
2. Rotate the filter counterclockwise	1.Place a rag under washer filter not to wet the floor.
and pull out the filter.	2.Turn the filter-cap to the left.
3. Remove dirts and rotate	3.Take the filter out and
the filter clockwise	remove dirts.
until it locks in position.	4. Reassemble in
	reverse order.

CLEANING THE FILTER NET Clean the filter net often to keep the washer clean.

1.Push the upper part of the filter and pull in.

2. Open the cover as	3. Clean the filter.	4. Close the cover and insert the
shown in the figure.		lower part of the filter in the
		basket first and then push the
		filter with "click" sound .