Samsung DV220AG* Important to Installer, Location Considerations, Alcove or Closet Installation

Page 10

installing your dryer

If the new Dryer is installed into an existing exhaust system you must make sure:

The exhaust system meets all local, state, and national codes.

That a flexible plastic duct is not used.

To Inspect and clean all lint buildup from inside the existing duct.

The duct is not kinked or crushed.

The exhaust hood damper opens and closes freely.

The static pressure in any exhaust system must not exceed 0.83 inches of water column, or be less than 0.

This can be measured while the Dryer is running with a manometer at the point where the exhaust duct connects to the Dryer. A no-heat setting should be used. The Dryer tumbler should be empty and the lint filter clean.

IMPORTANT TO INSTALLER

Please read the following instructions carefully before installing the dryer. These instructions should be kept for future reference.

REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES TO AVOID THE DANGER OF A CHILD WARNING SUFFOCATING.

LOCATION CONSIDERATIONS

The dryer should be located where there is enough space at the front for loading the Dryer, and enough space behind for the exhaust system. This Dryer is factory-ready for rear exhaust. To exhaust out the bottom or the left, use the accessory exhaust kit. Instructions are included with the kit. It’s important to make sure the room has enough fresh air. The Dryer must be located where there is no air-flow obstruction.

On gas Dryers, adequate clearance as noted on the data plate must be maintained to ensure adequate air for combustion and proper Dryer operation.

THE DRYER MUST NOT BE INSTALLED OR STORED IN AN AREA WHERE IT WILL BE EXPOSED TO WATER AND/OR WEATHER. THE DRYER AREA IS TO BE KEPT CLEAR OF COMBUSTIBLE MATERIALS, GASOLINE, AND OTHER FLAMMABLE VAPORS AND LIQUIDS. A DRYER PRODUCES COMBUSTIBLE LINT. THE AREA AROUND THE DRYER SHOULD BE KEPT LINT-FREE.

ALCOVE OR CLOSET INSTALLATION

The Dryer must be exhausted to the outside to reduce the risk of fire when installed in an alcove or

WARNING closet.

No other fuel-burning appliance should be installed in the same closet as the Dryer.

WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED TO THE OUTDOORS. See EXHAUST INFORMATION section.

Minimum clearances between the Dryer and adjacent walls or other surfaces are: 2” in front, 17” on top, 1” on either side, and 2.375” in the back.

The closet front must have two unobstructed air openings for a combined minimum total area of 72 in² with 3” minimum clearance on the top and bottom. A louvered door with equivalent space clearance is acceptable.

10_ installing your dryer

DV220AE-02810A-03_EN.indd 10

2010-06-28 ¿ÀÈÄ 5:53:28

Image 10
Contents Gas and Electric Dryer Thank you for purchasing this Samsung productFeatures Important Safety Symbols and Precautions Safety instructionsWhat YOU Need to Know about Safety Instructions Property damageSafety instructions What to do if YOU Smell GAS Safety instructions Contents Control panel Door Adjustable legs Installing your dryerTools Needed for Installation See Dryer ExteriorElectric and GAS Dryer Recommended Use only for short-run installationDucting Requirements Weather Hood TypeAlcove or Closet Installation Important to InstallerLocation Considerations United States Mobile Home InstallationExhausting CanadaGAS Requirements Commonwealth of Massachusetts installation instructionsUse only natural or LP liquid propane gases Grounding Wiring diagram is located on the back of the dryerElectrical Requirements Gas modelsElectric models U.S. only Electrical ConnectionsGas models U.S. and Canada Electric models Canada OnlyTools and Parts Replacement Parts and AccessoriesInstallation By turning them clockwiseModels Wire system connections Final Installation ChecklistConductor Dryer Exhaust Tips Inspect and clean the exhaust system annuallyDon’t let a poor exhaust system slow drying by Door Reversal Unplug the power cordFrom the door hinge Remaining holes Installing your dryer Door hinge To the dryer Remove two screws fromOperating Instructions, tips Overview of the Control PanelDisplay Power buttonDigital Graphic Dry LevelChild Lock Setting/ReleasingHow to Set Function to prevent children from playing with your dryerSuggested Items Suggested TEMP. Settings Installing the drying rackRack DRY Optional Part Load the Dryer Properly Clean the Lint FilterCleaning the Lint filter Getting StartedCare and cleaning Special Laundry Tips Special laundry tipsThings to Avoid Problem Solution TroubleshootingCheck These Points if Your DRYER… Error Display Meaning Solution Information CodesAppendix Fabric Care ChartWash Cycle Special Instructions Laundering Protecting the Environment SpecificationsDeclaration of Conformity Cycle Chart CycleWarranty Samsung Dryer Limited Warranty to Original PurchaserDV220AE-02810A-03EN.indd Questions or COMMENTS? Secadora a gas y eléctrica Gracias por adquirir este producto SamsungCaracterísticas Símbolos Y Precauciones DE Seguridad Importantes Instrucciones de seguridadLO QUE Necesita Saber Sobre LAS Instrucciones DE Seguridad MuerteInstrucciones de seguridad QUÉ Hacer SI Percibe Olor a GAS Advertencia Contenido Instalación DE LA SecadoraConsulte Exterior DE LA Secadora Instalación de la secadoraHerramientas Necesarias Para LA Instalación Panel de control Puerta Patas ajustables10,16 cm 6,35 cm Requisitos Para EL Tendido DE ConductosSecadora Eléctrica Y a GAS Instalación de la secadoraImportante Para EL Instalador Consideraciones Acerca DE LA UbicaciónEn los Estados Unidos Instalación EN Casas RodantesDrenaje En CanadáRequisitos EN Cuanto AL GAS Modelos a gas Requisitos EléctricosConexión a Tierra Modelos eléctricosModelos eléctricos Sólo EE.UU Conexiones EléctricasModelos a gas EE.UU. y Canadá Modelos eléctricos Sólo CanadáInstalación Reemplazo DE LAS Piezas Y LOS AccesoriosHerramientas y piezas Modelos Estadounidenses Conexiones de sistemas de 3 Cables Lista DE Verificación Final DE LA InstalaciónConexiones de sistemas de 4 Cables Sugerencias Acerca DEL Drenaje DE LA Secadora Delantero Paso 4 en el marco Retire los dos tornillos Inversión DE LA PuertaDesconecte el cable de Vuelva a colocar los Alimentación Del lado opuesto de laDescripción General DEL Panel DE Control Selector de CiclosSelección Ajustar tiempoBotón de Prevención deCómo configurarla Configuración/LiberaciónSeguro Para Niños Prendas Sugeridas Opciones DE TEMP. Sugeridas Secado EN Estante Pieza OpcionalInstalación del estante de secado Suéteres lavables Low Baja o Extra Low ExtrabajaCómo Comenzar Limpie EL Filtro Para PelusasCargue LA Secadora DE Manera Adecuada Limpieza del filtro para pelusasCuidado y limpieza Sugerencias Para Prendas Especiales Sugerencias para prendas especialesArticulos QUE SE Deben Evitar Problema Solución Controle Estos Puntos SI SU SECADORA…Pantalla DE Significado Solución Error Guía de solución de problemasCódigos DE Información Plancha ApéndiceTabla DE Indicaciones Sobre LA Tela ColorDeclaración DE Conformidad Protección DEL Medio AmbienteEspecificaciones Tabla DE Ciclos CicloGarantía SamsungDV220AE-02810A-03MES.indd ¿TIENE Preguntas O COMENTARIOS?