FEATURES
ÖActive
ÖActive Clear Sound (ACS) circuit for enhanced sound reproduction
ÖSound mode control
Ö
Ö
ÖSkip Play/Search Play/Repeat Play/Random Play
ÖProgrammed play of up to 20 tracks
Ö
ÖAuto reverse
ÖAuto tape select mechanism
ÖMetal (type IV) and CrO2 (type II) tape can be played back for superior tone quality
ÖCrO2 (type II) tape recording capability
Ö
ÖSeek/manual tuning
ÖAuto preset tuning
ÖTimer/Clock function
ÖTimer on/off with preset volume function
ÖSleep timer can be set for up to 120 minutes
ÖShoulder strap
ÖDC IN 12 V jack for car battery
SAFETY PRECAUTIONS
Prevention of Electric Shocks, Fire Hazards and Damage
1.Even when the button is set to STANDBY, a very small current will flow. To save power and for safety when not using the unit for an extended period of time, disconnect the power cord from the household AC outlet.
2.Do not handle the power cord with wet hands.
3.When unplugging from the wall outlet, always grasp and pull the plug, not the power cord.
4.Consult your nearest dealer when damage, disconnection, or contact failure affects the cord.
5.Do not bend the cord severely, or pull or twist it.
6.Do not modify the power cord in any manner.
7.To avoid accidents, do not remove screws to disassemble the unit and do not touch anything inside the unit.
8.Unplug the power cord when there is a possibility of lightning.
9.If water gets inside the unit, unplug the power cord from the outlet and consult your dealer.
10.Do not block the unit’s ventilation holes that allow heat to escape. Do not install the unit in a badly ventilated place.
button
When the power cord is connected to a household AC wall outlet, the power indicator lights in red indicating the STANDBY mode (only
when AC power is used). When the button is pressed, the power indicator goes out and the display window lights (when using DC power, it lights for only 5 seconds).
When this unit is plugged into an AC wall outlet, it consumes a small current to operate the remote control and timer, or to back up the
memory of the microprocessor, even when the button is set to
STANDBY.
Caution:
Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
1. Front:
No obstructions and open spacing.
2. Sides/Top/Back:
No obstructions should be placed in the areas shown by the dimensions below.
3. Bottom:
Place on a level surface. Maintain an adequate air path for ventilation by placing on a table with a height of 10 cm or more.
Front view | Side view |
15 cm
15 cm
15 cm | 15 cm | 15 cm |
ACTIVE
10 cm
10 cm
4