I d e l i n e s t o, Side-By-Side, Stacked

Washer:

•Install separate Hot & Cold faucets within 42" of the washer inlet.

•Provide a standpipe, 1-1/4" min. dia. and 24" min., 58" max. high. The attached drain hose will reach a 58” standpipe.

•The washer must be supplied with 120 volt, 60 Hz., and connected to an individual, properly polarized and grounded branch circuit protected by a 15 amp circuit breaker or time delay fuse. The 3 prong receptacle must be located where it will be accessible when the washer is installed. Power cord

length is 36".

•Follow the installation instructions packed with the product to remove shipping bolts and materials.

•Some installations require a pan to hold the washer. Local codes to apply. Pan size to fit washer.

*Note: Standpipes up to 96" high can be accommodated with a longer drain hose.

G u i d e l i n e s t o

Side-By-Side

36"

25-3/4"

53-1/2"

• This laundry pair requires a 53-1/2" wide space. No special installation requirements, install in the same manner as any other laundry pair.

• Allow additional 3" minimum behind the dryer for duct connection and 1-1/2" minimum behind the washer for standpipe.

Dryer:

•Provide 4" min. dia. rigid metal duct for best performance. Plan the shortest and straightest duct run possible. The dryer must ALWAYS be exhausted to outdoors.

•Electric models can exhaust 4 ways, from the right or left side, rear or bottom. Gas models can exhaust 3 ways, from the right side, rear or bottom. Both gas and electric models are shipped for rear exhaust.

•The dryer must be connected to an individual branch circuit protected by the required time delay fuses or circuit breakers. 208V or 240V installation requires 30 amps. (Gas dryers require 120V, 60Hz, 15 or 20 amp circuit.) Locate the receptacle where it will be accessible when the dryer is installed. Power cord length is 36".

•Follow the installation instructions packed with the product to complete the installation.

Note: Do not discard shipping bolts, clips or any parts removed during installation. The consumer should keep unused parts for possible future use or shipping.

Washer Clearances:

•Allow 1-1/2" from the back of the washer to rear wall for drain hose and standpipe. 0" to both sides.

Stacked

70-5/8"

25-3/4"

26-3/4"

Optimize space and efficiency.

Dryer Clearances:

•0" to either side, 3" rear, 3" clearance at the front, when installed into a recess or closet. When installed in a closet allow a min. of 120 sq. inches of opening such as louvers on the door.

•For complete installation instructions refer to washer Pub. No. 31-2819 and dryer Pub. No. 49-9963.

No trim kits to order, no additional cost. Mounting brackets are supplied with the dryer.

•Remove washer top cap, install brackets and mount the dryer over the washer.

•The stacked pair is only 70-5/8" tall. The dryer door will be eye-level, an easy reach for most users.

•Install the washer and dryer according to the installation instructions packed with the products.