GE DBXR453ET, DBXR453GT Before you call for service, Problem Possible Causes What to Do

Page 15

Before you call for service

Problem

Possible Causes

What to Do

Dryer is unplugged

Fuse is blown/circuit

breaker is tripped

Fuse is blown/circuit breaker

is tripped, the dryer may tumble but not heat

Gas service is off

Make sure the dryer plug is pushed - comFdetely into the outlet.

Check the house fuse/circuit breaker

box and replace fuse or reset breaker. NOTE."Most electric dryers use two breakers.

Check the house flase/'circuit breaker box and replace fuse or reset breaker.

Make sure gas shutoff at dryer and main shutoff are fully open.

Some shaking/noise is normal.

• Move dryer

to an

even floorspace, or adjust

Dryer may be sitting unevenly

as necessary

until

ewm.

Improper use of fabric softener

Drying dirty items with clean ones

Clothes were not completely clean

Follow directions on fa 3ric softener package.

Use your dryer to dry only clean items. Dirty items can stain clean items and the dryer.

Sometimes stains which cannot be seen when

the clothes are wet °appear" after d ,1,1TingUse.

proper washing procedures before drying.

Lint Filter

is full

 

• Clean lint screen before

each

load.

 

Improper

sorting

 

• Sort

lint

producers

(like

chenille)

from

 

 

 

lint

collectors

(like corduroy).

 

 

Static dectricity

can attract lint

* See

suggestions

in this section

under

STATIC.

Overloading

 

 

• Separate

large

loads

into

smaller ones.

Paper, tissue, etc. left in pockets • Empty" all pockets before laundering clothes.

15

Image 15
Contents Dryer Before Using DryerHelp us help you 800.626.2000 Iwarning For Read all safety information before usingRead all safety information before using Page Not Operate the Dryer Without the Lint Filter Place Appliance On your Dryer Cycle Descriptions Other dryer features your model has Specialty Care Guide Separate by fabric type LoadingClare & Cleaning Wire and clean duct Problem Possible Causes What to Do Before you call for serviceOrd/mg Problem Venting must conform to local buildin9+codes Page Page Page GE-CARES Well be there800.626.2000 800-626-222# Part No D1807P073 Pub. No