GE DBXR453ET, DBXR453GT owner manual Specialty Care Guide

Page 11

Specialty Care Guide

Always follow Fabric Manufacturer's Care Label or instructions when laundering.

Otherwise use the information below as a general guide.

P_ ovocs

Blankets

Col.ton

Sy_Lthetic

Down

Extra Large Items

(Includes

comforters

blankets and

mattress pads.)

Mend any holes or weak seams where feather or filling could

escape. Dry only one pillow at a time. Stop dryer occasionally and

shake pillow, redistributing filling for even drying. Check: pillow

at the end of drying time. If it is not completely dry, reset dryer for more drying time.

Dry on low heat only.

CAUTION: Do not dry pillows containing foam rubber.

Add 2-4 dry towels and one blanket and set timer for 20-25 minutes.

Dry only one blanket at a time. Do not set control for more than 25

minutes. At the end of drying cycle block the blanket back to its

original shape. Allow blanket to dry thoroughly before storing.

Use a medium heat drying setting.

Use a low heat drying setting.

Use a low heat drying setting.

Use a low heat drying setting.

Set dryer for 20 minutes. When time is up, check and redistribute load. Reset dryer for 15 minutes. When time i:;up, check ;and redistribute load. Reset timer tor 5 minute intervals. Check after each 5 minutes to ensure articles do not fill dryer drum. Large, wet articles should have ample room in the dryer, but as they dry and fluff up they may not have room to tumble.

CAUTION:Items without room to ramble may bliock air flow and could result in scorched items. Dry mattress pads separately. Use a low heat drying setting.

11

Image 11
Contents Dryer Help us help you 800.626.2000 Before UsingDryer Iwarning For Read all safety information before usingRead all safety information before using Page Not Operate the Dryer Without the Lint Filter Place Appliance On your Dryer Cycle Descriptions Other dryer features your model has Specialty Care Guide Separate by fabric type LoadingClare & Cleaning Wire and clean duct Problem Possible Causes What to Do Before you call for serviceOrd/mg Problem Venting must conform to local buildin9+codes Page Page Page GE-CARES Well be there800.626.2000 800-626-222# Part No D1807P073 Pub. No