15 Programme selector dial
The selector is divided into 5 sections:
•Cotton, linen
•Synthetics
•Delicates
•Woollens (hand washing)
•Special programmes
•Reset programme X
X 95º E
60º 50º
40º
30º
30º | 60º |
40º | 50º |
|
30º 40º 30º 40º
The selector dial can be turned either clockwise or anticlockwise.
Position E corresponds to the ENERGY SAVING programme and position to “cold wash”.
At the end of the programme the selector dial must be turned to position X (reset).
Interrupting a programme
Depress the START/PAUSE button to interrupt a programme which is running, the corresponding light starts to flash.
Cancelling a programme
Turn the selector dial to X to cancel a programme which is running: three flashing dashes appear on the display. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to PAUSE by pressing the START/PAUSE button .
If the door does not open, this means that the machine is already heating or drying, that the water level is above the bottom edge of the door or that the drum is turning. During drying the door can be opened only the first 10 minutes and at the end of drying (after the cooling phase).
If you cannot open the door but you need to open it you have to switch the machine off by depressing the ON/OFF button . After about 3 minutes the door can be opened (pay attention to the temperature and level of the water!). To restart the programme depress ON/OFF button again after closing the door.
Functions
Pilot lights
Depending on the programme, different functions can be combined.
When the relevant buttons are pressed, the corresponding pilot lights come on.
When they are pressed again, the pilot lights go out. If an incorrect option is selected, the pilot light flashes for about 2 seconds and the message Err is displayed.
End of programme
The door can be opened when the light (END) on the programme progress display illuminates.
A flashing zero appears on the display. Turn the programme selector dial to X.
Switch the machine off and remove the laundry.
Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only reset it by turning the programme selector dial to X and then you can select the new programme.
Start it by depressing the START/PAUSE button .
Programme information
= Wool / Hand wash
Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics with the “hand washing” care symbol.
= Soak
Select this programme for heavily soiled laundry. Pour the detergent into the compartment . This programme is not suitable for wool.
The machine performs a soak at 30°C and stops with the water in the drum. The water can be emptied out in
2 ways:
•Draining only by depressing the START/PAUSE button .
•Draining and spin: turn the programme selector dial to X, select programme (spin), reduce eventually the spin speed by means of button and depress START/PAUSE button.
Important!
•If the water is not emptied out within 18 hours, the machine empties automatically.
9