Cannon IWDE Installation, Unpacking and levelling, Connecting the electricity and water supplies

Page 2

Installation

GB

! This instruction manual should be kept in a safe place for

future reference. If the washer-dryer is sold, transferred or

 

 

moved, make sure that the instruction manual remains with

 

the machine so that the new owner is able to familiarise

 

himself/herself with its operation and features.

 

! Read these instructions carefully: they contain vital infor-

 

mation relating to the safe installation and operation of the

 

appliance.

 

Unpacking and levelling

 

Unpacking

 

1. Remove the washer-dryer from its packaging.

 

2. Make sure that the washer-dryer has not been damaged

 

during the transportation process. If it has been damaged,

 

contact the retailer and do not proceed any further with the

 

installation process.

 

3. Remove the 4 protective

 

screws (used during tran-

 

sportation) and the rubber

 

washer with the correspon-

 

ding spacer, located on the

 

rear part of the appliance

 

(see figure).

4.Close off the holes using the plastic plugs provided.

5.Keep all the parts in a safe place: you will need them again if the washer-dryer needs to be moved to another location.

!Packaging materials should not be used as toys for children.

Levelling

1.Install the washer-dryer on a flat sturdy floor, without re- sting it up against walls, furniture cabinets or anything else.

2. If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjusta- ble front feet (see figure); the angle of inclination, measured in relation to the worktop, must not exceed 2°.

Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washer-dryer.

Connecting the electricity and water supplies

Connecting the water inlet hose

1. Connect the supply pipe by screwing it to a cold water tap using a ¾ gas threaded connection (see figure).

Before performing the con- nection, allow the water to run freely until it is perfectly clear.

2. Connect the inlet hose to the washer-dryer by screwing it onto the corre- sponding water inlet of the appliance, which is situa- ted on the top right-hand side of the rear part of the appliance (see figure).

3.Make sure that the hose is not folded over or bent.

!The water pressure at the tap must fall within the values indicated in the Technical details table (see page 5).

!If the inlet hose is not long enough, contact a specialised shop or an authorised technician.

!Never use second-hand hoses.

!Use the ones supplied with the machine.

2

Image 2
Contents Instructions for use WASHER-DRYERUnpacking and levelling InstallationConnecting the electricity and water supplies Replacement fuse covers Before using the appliance please read the instructionsBe used until a replacement is obtained If a replacement fuse cover is fitted, it must beFirst wash cycle Technical data Description of the Washer-dryer Control panelDisplay How to run a wash cycle or a drying cycle Close the DoorWash options Wash cycles and optionsTable of wash cycles Soiled cotton and synthetic fabrics refer to the TablePreparing the laundry Detergents and laundryDetergent dispenser drawer Special wash cyclesDisposal Precautions and tipsGeneral safety Opening the porthole door manuallyCare and maintenance Troubleshooting Problem Possible causes / SolutionsMachine is noisy Machine wont spin properlyReplacement of any removable parts made of glass or plastic AssistanceEssential Contact Information After Sales Service195089931.00 Recycling & Disposal Information
Related manuals
Manual 16 pages 31.49 Kb