Electrolux EW 1200 i manual Electrical connection, Permanent connection, Blue- Neutral Brown- Live

Page 29

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.

 

Mod

 

Prod. No

P0042

Ser. No

 

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363 A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

GREEN & YELLOW

E

13 A

L

N

BROWN

BLUE

P1041

CORD CLAMP

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the

earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal marked «N» or coloured black.

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

Should the appliance power supply cable neeed to be replaced, this should be carried out by our Service Force Centre.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

29

Image 29 Contents
Instruction Booklet Use InstallationChild Safety Contents Interest Environment Your New Washer-DryerEcological hints Prewash Main wash Fabric softener Description of the ApplianceDetergent dispenser drawer Control Panel Operating Sequence At the end of the programme Start the machineMachine stops automatically Washing 2 KG of Mixed Fabrics AT 50CSelect the required time Select the programmeDrying 2.25 KG of Cotton Turn the programme selector dial clockwise to programme JAutodrying 1 KG of Mixed Fabrics Select the required optionTurn the programme selector dial clockwise to programme K Depress Quick Wash button, if required1000g = 1 kg Washing and Drying HintsLaundry and placed in the tumble dryer Which detergent?Which form? Rinses Washing ProgrammesSofteners Long SpinOptions Degree of soil Programme Possible MaxShort Spin DrainDegree of drying Programme Max. load Spin speed Drying time Drying ProgrammesImportant Notes Wash Care SymbolsMaintenance and Cleaning Water inlet filters Clean carefully under a fast running tapIt is therefore a good idea to clean them from time to time Something Not Working Symptom Service & Spare Parts0870 5 Customer CareStandard guarantee conditions Guarantee ConditionsEuropean guarantee This guarantee does not coverPage Page Technical Specifications Installation InstructionsWashing Drying Unpacking Install the machine on a flat hard floor Positioning Never place cardboard, wood or similar materials underWater drainage Water inletInterest of the environment LevellingSpecial conditions Blue- Neutral Brown- Live Electrical connectionPermanent connection Building-in Preparation and assembly of the doorDrill four fixing holes see Fig. G