Building-in, Door, Hinges, Mounting the door

Building-in

This appliance has been designed to be built into the kitchen furniture.

The recess should have the dimensions shown in picture

A.
		600
				600
					.
	15	596	70		min
	5	596	5		820 min
	176,5	0			820 min
818	416	12
		1
		54
		8	1
		8	95
			95
		160
		0
	165	9
	165	0			A
P0965		49
P0965

When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped. Picture AB.

Preparation and assembly of the door

The machine is originally pre-arranged for the assembly of a door opening from right to left.

In this case it is sufficient to screw in the hinges (1) and the counter-magnet (6) provided with the appliance, at the right level (Fig. B).

6			4
			4
1	2	7	5
1	2	7	5
		3
23			B
P0982

a) Door

The dimensions of the door should be:

- width 595-598 mm - thickness 16-22 mm

The height (C-Fig. C) depends on the height of the adjacent furniture's base.

35 Ø 12.5-14 depth
16			B
-			B
	22
			416	C
				,5
			+1
			22
			598
		5-
		59
P0422S				C

b) Hinges

To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth 12.5-14 mm depending on the depth of door furniture) on the inner side of the door. The distance between the holes hobs fixing centres must be 416 mm.

The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions.

The required dimensions are given in the picture C. The hinges will be fixed to the door by means of screws for wood (2-Fig. B) supplied with the appliance.

c) Mounting the door

Fix the hinges (1) to the machine by means of the M5x15 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thickness of the door. To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door.

Its position must correspond to the magnet (4) on the appliance (see picture D).

	6
	4
P0984	D
P0984