20 operating problems
Problems |
| Causes | |
|
|
| |
|
|
|
|
The | appliance vibrates, is | • all packaging have not been removed from the | |
noisy : |
| appliance (see installation section), | |
|
|
| • the appliance isn’t level and is unbalanced, |
|
|
| • the appliance is too close to the wall or furni- |
|
|
| ture, |
|
|
| • washing is unevenly distributed in the drum, |
|
|
| • the load is too small. |
|
| ||
the wash cycle is much too | • the water inlet filters are dirty, | ||
long : |
| • the power or water supply has been cut off, | |
|
|
| • the motor overheating detector has been acti- |
|
|
| vated, |
|
|
| • the water inlet temperature is lower than usual, |
|
|
| • the foam detection security system has been |
|
|
| activated (too much detergent) and the washing |
|
|
| machine has begun draining the foam, |
|
|
| • the out of balance detector has been activated : |
|
|
| an extra phase has been added to distribute |
|
|
| washing more evenly in the drum. |
|
|
|
|
The | washing | machine | • the water or electricity supply is defective |
stops during a wash cycle : | • a Rinse hold has been selected, | ||
|
|
| • the drum shutters are open. |
|
| ||
The lid doesn’t open at the | • the “immediate opening”* light is not lit, | ||
end of the cycle : |
| • the temperature inside the drum is too high, | |
|
|
| • the lid unlocks 1 - 2 minutes after the end of the |
|
|
| cycle*. |
|
| ||
The E40 error code ap- | • the lid isn’t closed properly. | ||
pears in the display** and |
| ||
the | Start/Pause | pushbut- |
|
ton flashes red*** : |
|
| |
The E20 error code ap- | • the drainage filter is obstructed, | ||
pears in the display** and | • the drain hose is blocked or bent, | ||
the | Start/Pause | pushbut- | • the drain hose is fixed too high (see “Installa- |
ton flashes red*** : | tion” section). | ||
|
|
| • the drainage pump is blocked, |
|
|
| • the standpipe is blocked. |
|
|
|
|